Question about PC Desktops

1 Answer

Have Kodak Easyshare5300..installed new ink and still it is print very lightly..hard to read it

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 75 Answers

Try to clean your printer:

the printer have its built in program,try to see its utility mode and click clean printer heads
do it 3times;

if the problem is still there...try to clean heads manually
(but 1rst be carefull to damage the heads and the printer must be unplug while you're cleaning it)
get some cottonbuds and dip it to hot water{hot water can melt some molded residue in ink}
and slightly and carefully clean the printer head.

Posted on Oct 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Error message! I just got a Kodak 5210 printer and it keeps saying "printhead carriage jam. open printer access door. clear any obstruction. check installation of printhead and ink cartilages. close...


To resolve the error condition:

1. Disconnect the power adapter from the printer.

2. Wait 30 seconds to allow the printer to reset.

3. Connect the power adapter to the printer. Turn the printer on if necessary.

4. Wait until the printer is ready to use.

If the error condition continues:

1. Open the printer access door.

2. Remove and install the print head two times. - See http://faqs.kodak.com/atg/faq/attachments/AUR1780-2.pdf

3. Close the printer access door.

4. Wait until the printer is ready to use.

5. If the error is still displayed, contact Kodak


If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response

Thanks, Joe




Feb 03, 2011 | PC Desktops

2 Answers

How do I insert new ink cartridges in my HP 4385 all in one printer?


Buy a New model of printer... not that HP 4385... it so cheap yah...

Sep 23, 2010 | PC Desktops

2 Answers

Cannot print with only one cartridge


The inkjet printers are designed to print wit BOTH cartridges installed. You cannot fool it to print with only one.

Apr 18, 2009 | PC Desktops

1 Answer

Light printing..need to clean


Depening on which printer it is , but normally all vendors include a system utilty with their printers to do head alignment, calibration and cleaning, some have what is referred to as a deep cleaning cycle as well, which does consume a bit more ink but does sometimes get rid of very light printing. If nothing else has changed in preferences such as print in high speed draft mode(which will give lighter than normal printing) then do a few cleaning cycles and possibly a head re-alignment.

Apr 15, 2009 | PC Desktops

1 Answer

Royal Cash Register


Hi. There are several reasons for this.
The most common one is not replacing the ink roller on time. If the old roller had felt falling off of it, then it will block up the drum.
The second is re-inking the roller. If you do this, you end up with a sticky mess and a lot of smudging.
Other than that, pieces of paper stuck in the paper path are common.
You should inspect the drum again. This is the little group of rubber numbers that spin around and hit the paper while printing. You will usually find sticky muck on the numbers, and you may have to clean them several times. You need to turn the drum as you clean it. Try to use the gears at the side if they are visible. A dry Q-tip is best, as alcohol may damage the thin rubber. Try cleaning the drum again, and look for any improvement. If itgets better on some numbers, then you are probably on the right track. Also, if you could send me a picture of the bad print, that may help also.

Good luck.

Mark

Aug 09, 2008 | Casio Parts Cash Register PC Desktop

1 Answer

Put in new ink cartridge printer asked me did I want an alignement test print I said yes now every time I want to print some work a test print is printed as soon as I try to print any weork off could


After installing the new ink, it will print a paper for U. put that paper in the scanner and press scan. It's a self-calibration. If that's not the problem, please state what the problem is.

Jun 10, 2008 | PC Desktops

1 Answer

I am trying to use a Z705 color jetprinter, but cannot get it to print from the pc. I can print from notepad (not using the print file from the tool bar but from the notepad file. I have tried everything....


May be you are not installed well the software driver of the printer. First check the test page of the printer.

For test page see the option of the printer icon.right click icon goto the properties and click test page. Then it will not print well after that put the driver cd into the cd drive and install the software.try it and if the prob comes again please inform to fixya.com

May 12, 2008 | PC Desktops

1 Answer

New Ink cartridges registering as empty ...


Is it an HP printer? We had the same problem at work with print cartridges purchased at Staples. They have a major quality control problem. Your new print cartridge may be empty or dried out (died on the shelf). It's my problem at work, as I have over 80 HP deskjets, and Purchasing still insists on buying the Staples cartridges rather than the HP.

Sometimes if you shake a print cartridge really hard it may correct the problem. However, I would buy or borrow a black HP print cartridge and try it out in your printer. Works almost every time on the job. Good luck.


Apr 17, 2008 | PC Desktops

1 Answer

Low ink level after ink refill prohitting print function


Click on your lexmark maintenance tools and click on install new cartridge. This should fix your problem.

Mar 29, 2008 | PC Desktops

Not finding what you are looking for?
PC Desktops Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top PC Desktops Experts

joecoolvette
joecoolvette

Level 3 Expert

5660 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18304 Answers

Are you a PC Desktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...