Sud and f 35 code - Whirlpool Duet GHW9150P Front Load Washer

ok...run unit on rinse and spin only,,we need cold water,,if unit still shows sud error make sure drain hose is not kinked,,,if we still have a sud condiction or error ,,remove toe panel and clean filter.good luck

SUD= The "Sd" code indicates that you have added too much detergent to the washing machine and your laundry has too many suds. The machine will stop displaying this code if it has successfully run the suds recovery cycle, which removes the excess suds from the wash load. If the code remains, reduce the amount of detergent in the load. Use less detergent for similar loads of laundry in the future
As far as F35. Check your owners manual to see if its in there. Also if you remove the top lid ( a couple screws in back hold it in place) and check inside you will get the technician diag sheet which will have codes.

aha F-35?
F-35: Analog switch/water level failure

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

If it is similar to the Whirlpool duet,

Try using less soap (hi eff machine)
try using more fabric softner
to clear the occasional Sud warning, I run the machine on "quick wash" with no detergent/additive. gives it two more quick spin cycles in 30-35 minutes, usually clears it.

Save yourself a lot of time and money and replace the analog pressure switch. This will solve your issues by taking care of both error codes at the same time.

The Appliance Pro

An F 35 error in fact means any number of things, from the drain hose being pushed too deeply into the standpipe to using the wrong soap or too much soap and the computer triggering an over-suds condition. Your best bet is to contact Whirlpool.

sounds like the wrong soap. are you using H E soap?

its junk and it should be a crime t sell to hard working people never did work good and it needs to go back across the ocean junk yard won even take it

try clean drain pump. be careful their lot of water in you washer. remove front bottom panel to get to drain pump. i hope i will solve your problem.