Question about Pioneer Audio & Video Receivers

1 Answer

I have a pioneer 5.1 channel surround sound system and it powers up and everything seems to go fine but you go to turn it up and no sound comes out of the speakers already checked speaker wire connections and everything is connected fine but still no sound please help

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 142 Answers

Does the protection relay click 3 to 5 seconds after initial power on??? If not, your unit is staying in "protect" mode to save your speakers because the output transistors or output IC is shorted and sending 40 to 60 volts at your speakers. Not a good thing, but at least it saves your speakers.
Good Luck!

barneyluc

Posted on Oct 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

No surround sound


Check the wiring while it is ON, there might be a loose wiring... also check the power of the amplifier... then check the TV setting for the activation of the surround system...

Post me the results... hope this Fixya the problem...

Feb 17, 2008 | Harman Kardon AVR 630 Receiver

2 Answers

Cracking and poping with Yamaha surround sound system


Try put a ground line from any metal of your stuff to the any metal direct to the ground. these eliminate noise of the speaker.

Jan 03, 2008 | Pioneer VSX-54TX Receiver

1 Answer

Pioneer VSX-818V-K Receiver


wondering if input levels are too high on some channels causing safety limits to shut it out..check level outputs on eguipment.

Jan 08, 2014 | Pioneer VSX-818V-K Receiver

2 Answers

Pioneer VSX-72TXV wont power up. mcacc light just blinks.. unit does not have a video 2 button on the face.


try holding the "TUNE -" button and the ZONE 2 on/off button and see if it turns on. If its turns on, but turns back off again, you either have a problem with your speakers (try disconnecting them) or there is a problem with the receiver that needs to be repaired.

Dec 06, 2013 | Pioneer VSX-72TXV Receiver

1 Answer

I have the following setup: AV Receiver: Pioneer


Very common problem with today's receivers. Receivers made today don't have a true preamp section in the amplifier and do not amplify the sound to the extent of an older receiver. I have large 15" front speakers on my system, and have stuck with my 15 year old receiver just because I know that a new receiver will not have the power to drive them well. Many of the newer receivers need to be turned up to 50-60% before you can even hear anything from the speakers.

Aug 08, 2013 | Pioneer Audio & Video Receivers

1 Answer

I have pioneer receiver Vsx-454 i want to know if this receiver is 5.1 surrounds


Yes. It is 5.1 surround. There are 2 front channels, 1 center channel, and 2 rear channels which comprise the "5" in 5.1 surround. The pre-amp output channel for a sub is the ".5".

Jan 11, 2009 | Pioneer VSX-454 Receiver

2 Answers

Reciever only allows 2 channels(speakers) at a time.


I had this problem too. Finally, after using the MCACC setup and making sure all the speakers worked, I found I had to set the source to FM, TV or whatever from the remote control and set the mode to advanced surround sound using the front panal button on the upper right. Had to fool with them a lot. Good luck.

Jan 03, 2009 | Pioneer VSX-818V-K Receiver

3 Answers

I have a Pioneer HTV-C2 center channel virtual surround speaker system with a powered subwoofer.When i plug everything in and power it up i get a quick 3 second burst of sound and then it stops,but the...


i have a Pioneer HTV-C2 center channel virtual surround speaker system with a powered subwoofer.Lost the cables, can somebody help me, dont know where to get them???......original cable part # are
ADX-7239 this is the system cable A and (rectangle connector)
ADE-7023 this is the subwoofer cable B.....(round connector) 8 pins both
is there any compatible cable....thanx apprecieate ur help!!!

Jun 30, 2008 | Audio & Video Receivers

Not finding what you are looking for?
Audio & Video Receivers Logo

Related Topics:

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Audio & Video Receivers Experts

Steve Sweetleaf
Steve Sweetleaf

Level 3 Expert

1128 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

gbob59

Level 3 Expert

2963 Answers

Are you a Pioneer Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...