Question about Computer Monitors

1 Answer

Blinking or wavery screen

Samsung syncmaster 226bw 22" flat screen

Posted by on

  • Kitt123 Nov 28, 2008

    My monitor screen will only come on momentarily, when I click the standby button, and wiggle the mouse.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 62 Answers

1. cheak display cable in blinking position.

2. Voltage problem. main capacitor 220mf / 420v .
3. ptc problem.
4. cheak out put capacitors
5 electrical distabence.

Posted on Nov 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

SAMSUNG SYNCMASTER 226BW WHEN TURNING ON MONITOR, IT SHOWS BLACK AND WHITE LINES THEN IT SHOWES A BOX THAT SAYS "NOT OPTIMUM MODE, RECOMMENDED MODE 1680 x1050 60HZ " AND IT IS STUCK ON THIS...


hi dear

start your computer on safe mode and go to the display property change to as per mentioned rresolution on your screen.

best of luck

regards

raj

Sep 06, 2011 | Samsung Computer Monitors

1 Answer

My samsung 226bw (analog) monitor will not shut off. It goes black when the power button is pushed but then the analog square comes up and the screen is brought back up to where it was when I hit the...


it is probably the power button itself, or there is something wrong with the power board inside the monitor, the capacitors are probably on their way out, in these monitors cheap capacitors are used and they seem to fail within 2-3 years, these can be replaced by a professional and would probably be cheaper than buying a new one. either way, if the picture on the monitor is OK, you could just switch it off at the socket or wait for it to go into power saving mode.

Apr 27, 2011 | Samsung SyncMaster 226CW 22" Monitor

1 Answer

Samsung syncmaster 226BW fails to wake up.


If pc not sending it to "sleep mode" or "power save" mode, then unit may need help of electronics technician to investigate the "internal switch-mode-power-supply" that may be going into "shutdown" mode after it detects a "fault condition" with itself or onother circuit.
12fixlouie

Sep 20, 2010 | Samsung SyncMaster 226CW 22" Monitor

1 Answer

SyncMaster 226BW is stuck in standby or at least it shows the signs of being in standby (blinking power button / no display). This happened over night, and a simple restart doesn't seem to fix the issue.


Try it on another PC first, check VGA cable, but more likely to be the monitor for monitor this old.
Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed SAMSUNG monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://www.badcaps.net
http://en.wikipedia.org/wiki/Capacitor_plague

Apr 28, 2010 | Samsung SyncMaster 226CW 22" Monitor

1 Answer

Samsung syncmaster 226BW no backlight


Look for any bulging capacitors, instead of a flat top they will look "pregnant".

If you see any of those then replace them with capacitors of the same UF rating and the voltage needs to be either the same or higher.

If you dont see any bulging capacitors or burnt parts, then its got be the LCD at that point thats not staying on and the cost to replace the LCD is as much if not more then to just get another monitor.


Aug 27, 2009 | Samsung 226BW Monitor

2 Answers

Samsung SyncMaster 226bw 22inch flickers/blinks on startup


Solution = Sledgehammer. My 226BW has been taking ages to warm up for a while and now it is a permanent dull flicker.

Aug 26, 2009 | Computer Monitors

2 Answers

Samsung SyncMaster 226BW - floating box "Check Signal Cable"


had the same issue, called up customer care of samsung and they suggested me to change the cable to D-15 10 series. I was getting the comp o/p on TV but with the "Check Signal Cable" messg with the old VGA cable where some pin is not grounded used for computer to monitor connectivity.
Abhi..

Jul 25, 2009 | Samsung SyncMaster 2233BW 22" LCD Monitor

2 Answers

Samsung 226BW 22" LCD wont turn on and flickers a blue light


Hello cstafford35,

Your monitor has a very common problem. The internal power supply has blown a part called a capacitor. If you are comfortable working with electronics and with soldering I can talk you thru the diag/repair. If you are not ready to tackle that we also offer a repair service, about $30 plus shipping for your model. Let me know if you want to try fixing it yourself and we can go from there. The repair will require opening the monitor case and replacing from 2 - 5 parts. You can call me at 318-447-9040 if you have questions.

Buddy
Corporate Computer

Jun 17, 2009 | Samsung 226BW Monitor

1 Answer

Window screen problem


I'm guessing you may need to download the proper software and drivers for this monitor. Have you always had this problem and now want to change it? Try this website: http://static.tigerdirect.com/pdf/samsung-206bw-manual.pdf

Jun 21, 2007 | Samsung SyncMaster 214T 21.3" LCD Monitor

Not finding what you are looking for?
Computer Monitors Logo

Related Topics:

657 people viewed this question

Ask a Question

Usually answered in minutes!

Top Computer Monitors Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18297 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Computer Monitor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...