Question about Pride Jazzy 1113 ATS Indoor Power Wheelchair

3 Answers

Jazzy 1113 chair will start to power up. Yellow light in speed control will flash about 4 times then shut its self down. Bought and changed batteries last night still have same problem.   thanks  Craig

Posted by on

  • 2 more comments 
  • craigcarl Sep 30, 2008

    jaxxy 1113 chair will start to power up. Yellow light in speed control will flash about 4 times then shut its self down. Bought and changed batteries last night still have same problem.I checked brakes, all plugs and and rechecked battery cables.Charger shows about 3 amps but when charger is unplugged guage goes to 0. Same after 12 hrs charge.motor brushes are a possible solution, not sure what indicator light should show if brushes thanks Craig

  • Anonymous Mar 11, 2014

    acer t 5520 hard disk bios password can not be open bios plz help me bios password and hard disk password resat

  • Anonymous Mar 11, 2014

    Microwave oven is not working at. Earlier it was showing E-10 error, but after few days o cleaning of controller it is showing E-18 error code

  • Anonymous Mar 11, 2014

    oxygen sensor

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 32 Answers

Right motor fault

Posted on Apr 03, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 726 Answers

Could be a problem with the (go) switch check there is power going to it and also check if there is power to the motor other wise it could be the motor check using a testing light

Posted on Sep 30, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,952 Answers

Check wiring and pcb in your chair...it may be loose connection in between the path

Posted on Sep 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

My chair will not change speeds. Very slow, No flashing lights


That is possible. Check the power circuit from the battery and see if there is any loose connections or resistance in the circuit via the voltage drop method. Here are some links that may help:

Jazzy 1113 ATS Parts

Redirect Notice

Redirect Notice

Mar 03, 2015 | Pride Jazzy 1113 Power Chair

1 Answer

Jazzy chair 600 3 red lights 4 yellow 1 green no power both batteries read 12.5


Have the joystick controller tested. Make sure the cable is fully seated in the chair connector.

Feb 17, 2014 | Pride Jazzy 1113 ATS Indoor Power...

1 Answer

Pride jazzy 1113, controller light scroll back and forth, wont move, i bought one new battery, it has full charge other battery is a little over 10 volts. is there way to test charger with volt meter?


The voltmeter should read 29 volts when on. You should never replace one battery and leave an old battery in the chair. Replace them both at the same time.

Oct 17, 2013 | Pride Jazzy 1113 Power Chair

1 Answer

Jazzy 1107 power chair won't move


3 flashes indicate that there is a short circuit to the left motor and battery connection. Check wiring and connections

Jun 14, 2013 | Pride Jazzy 1113 ATS Indoor Power...

1 Answer

Jazzy 1133 has new batteries. All lights are lit on the battery condition meter. Maximum speed/profile indicator constantly blinks no matter how many sements are lit. After I turn it off and waiting a...


If all lights are flashing excessive voltage has been applied to the controller system. 6 flashing lights on the 1133 indicates that the chair is being inhibited by the battery charger. Try unplugging the battery charger. Check you battery connections.

Mar 30, 2013 | Pride Jazzy 1113 Power Chair

1 Answer

The chair is locked. I had this happen a long time ago and I needed to move the joy stick diferent directions to get it unlocked but I do not remember how. It is a Jazzy 1113.


If it is the older VSI controller, turn on chair. as the battery lights scroll, hold the joystick in the (UP) position until you hear a beep. Then immediately place the joystick in the (down) position until you hear a beep. then place the joystick in center position, once you hear the beep for the final time, it should be unlocked.

If you have a Dynamic controller, turn on chair then press the horn button to unlock.

Sep 15, 2011 | Pride Jazzy 1113 ATS Indoor Power...

1 Answer

The jazzy 1113 will not start, when you press the power button the speed light comes on gets full and then turns back off


How old are the batteries? If you've had them for a few years it might be time to change them. Even if batteries are charged correctly they eventually lose power with use and need to be changed. Here is a link to the battery needed for the Jazzy 1113 http://www.replacementupsbattery.com/UB12350-NB.html

Nov 08, 2010 | Pride Jazzy 1113 ATS Indoor Power...

1 Answer

Jazzy 1113 ats won't start


How old are the batteries? If you've had them for a few years it might be time to change them. Even if batteries are charged correctly they eventually lose power with use and need to be changed. Here is a link to the battery needed for the Jazzy 1113 http://www.replacementupsbattery.com/UB12350-NB.html

Nov 04, 2010 | Pride Jazzy 1113 Power Chair

1 Answer

Have a jazzy 1113. The speed profile lights flash then the chair shuts off. The batteries show full.


The flash of the speed lights indicate that you are in the charger inhibit mode and if the charger is not plugged in then you have a problem that needs to be checked by a tech or your provider that sold you your chair Sorry I don't have a quick fix

Sep 25, 2010 | Pride Jazzy 1113 ATS Indoor Power...

Not finding what you are looking for?
Pride Jazzy 1113 ATS Indoor Power Wheelchair Logo

319 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pride Health & Beauty Experts

Robin Hill
Robin Hill

Level 3 Expert

1251 Answers

wcdoc1953
wcdoc1953

Level 2 Expert

278 Answers

Colin Taylor

Level 2 Expert

341 Answers

Are you a Pride Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...