Question about PC Desktops
Could be you have a faulty processor on your system or for some reason is failing when an operation was forwarded for the processor to execute and it failed to do it.
1. check your processor fans
2. if you were overclocking go into your bios/cmos program and set everything back.
Posted on Sep 30, 2008
Tips for a great answer:
Sep 17, 2015 | PC Desktops
on Mar 09, 2010 | PC Desktops
on Dec 30, 2009 | PC Desktops
Mar 07, 2014 | Dell PC Desktops
00 = Divide Fault
Occurs if division by zero is attempted or if the result of the operation does not fit in the destination operand.
Interrupt 2 is reserved for the hardware Non-Maskable-Interrupt condition. No exceptions trap through interrupt 2.
Occurs after an INTRO instruction has executed and the OF bit is set to 1.
05=Bounds Check fault
The array Index is out of range
06=Invalid Opcode fault
This error can be caused by one of the below conditions.
07=Copressor not available fault.
This error can occur if no math coprocessor is present. This error can also occur when the math coprocessor is used and a task switch is executed.
This error occurs when processing an exception triggers a second exception.
09(OD)=Copressor Segment Overrun.
Floating point operand is outside the segment.
10(0Ah/0A)=Invalid Task State Segment Fault
Can be caused by a number of possibilities as Task State Segment contains a number of descriptors.
11(0Bh)=Not Present Fault
The Not Present interrupt allows the operating system to implement virtual memory through the segmentation mechanism. 0B fault occurs when this segment is not available.
Occurs when instruction refers to memory beyond the limit of the stack segment.
13(Odh)=General Protection Fault
Caused by any condition that is not covered by any of the other processor exceptions. The exception indicates that this program has been corrupted in memory generally resulting in the immediate termination of the program.
Occurs when a paging protection rule is violated (when the retrieve fails, data retrieved is invalid or the code that issued the fault broke the protection rule for the processor).
16(10h)=Coprocessor error fault
Occurs when an unmasked floating-point exception has signaled a previous instruction.
17(11h)=Alignment Check Fault
Only used on 80486 computers. Caused when code executing at ring privilege 3 attempts to access a word operand that is not divisible by four, or a long real or temp real whose address is not divisible by eight.
Find out the reason of Fatal Error if that is due to Software related then go in safe mode and uninstall the software recently installed or udate them/patch them. or if the same is related to hardware then unplug the recently added hardware,
Aug 21, 2011 | PC Desktops
Jan 08, 2010 | Acer Aspire M5641 PC Desktop
Dec 10, 2009 | E-Machines eMachines Refurbished EMA...
Mar 07, 2009 | E-Machines eMachines Refurbished EMA...
Apr 20, 2008 | PC Desktops
142 people viewed this question
Usually answered in minutes!