Re: All my dad's pictures are coming out blue-ish...
Open the camera; set dial to 'I'; press the up button on the menu until 'exposure' appear; press once again until 'red-blue' slider appear; move slider to left/right in order to get the colour you want.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Could be the settings need adjusting.....to help you should check these settings and set to!
ISO to High ISO Auto.
AF to Auto
When taking the photo press the shutter button halfway till the window shows a green light (if the window red then not focused so release button and try again) then continue to press the shutter button till the picture is taken!
You might have chosen either to fast an ISO (i.e. 800 or 1600) or you have too much light entering the lens (sensor) in other words the automatic exposure is turned off manually or there is a fault, check first the menu options as a rough guide you should have the ISO set around 200 - 400 the aperture set around F6.3 to 8 with a shutter speed at 200 ish, all this depends on the brightness of the day but if you have auto exposure on which every new camera would have these days then that is all taken care of. Try different SCN and ISO to see if problem still persists. If the problem is intermitted, try to find a pattern in to when the faulty pictures appear.
Or else try to remove the memory card. Turn On camera without memory card, now press menu button and go to setup menu and under setup menu please look for format then press Ok, under format please format the internal memory.
Now if you already reformat the internal memory, take atleast 3 pictures on a same subject, then hit review if the lines appeared on both pictures on same location, it means camera needs of service please call Kodak toll free 1 800 235 6325., For U.S and canada support.
Hey JRochester, I would make sure the white balance settings were not changed somehow. Depending on your level of expertise I would set the white balance to auto if you are not familiar with white balance, and if you are make sure the white balance is set to your shooting conditions each time you capture and image. Sincerely, Allan Go Ahead. Use Us.
What are you looking at on the screen?
Before or after the shot?
The this point the taking sequence-point camera at scene look in screen blurry image - half press the release - autofocus comes into play- press all the way picture takes.Sharp picture in the taken images
what are you doing?
The only recommendation is to correct the colour balance in a photo editor in your computer
Come back here if you do not know about photo editing.
As far as the camera is concerned there is no remedy as far as I can see -its old age time for a new one
Repair is not an option.
The two pictures were shot at dramatically different exposures - the "dark" one at 1/1600 shutter speed, f7.3, the "light" one at 1/320 shutter speed, f4.0. This accounts for the great difference, as the exposure conditions for the "light" one allowed much more light into the image during the exposure period. You didn't tell the whole story of how you set this up, I think you were shooting in a "spot" metering mode, where the particular exposure conditions the camera uses would vary considerably whether you were aiming at a dark area (making the picture light) or a light area (making the picture dark).
I would make two recommendations: Switch your metering mode to "center weighted" (the mode labeled "[(•)]"), and also change your ISO setting to AUTO, as there would be no reason for shooting these photos at ISO 200 that I can think of.