Question about Samsung DLP HL-P5663W 56" TV

1 Answer

SAMSUNG DLP HL-S5086W

WHEN THE TV TURNS ON THE GREEN LIGHT BLINKS BUT IT NEVER COMES ON----ALSO NOW THE BULB LIGHTS UP BUT USUALLY TURNS OFF AFTER ABOUT 10 OR 15 SECONDS AFTER THE TV IS TURNED ON. ONCE AGAIN THE LIGHTS BLINK ON AND OFF BUT THE TV NEVER TURNS ON.

Posted by on

  • 1 more comment 
  • dlg99 Sep 29, 2008

    same problem with HL-R4266W... bulb turns on, i get a glow but no picture, then it turns off. i was told it's too expensive to fix ($750) and i should just get a new tv... is this true?

  • rystoy Oct 02, 2008

    Is the horizontal transistor on the power board?????

  • nknwnrc Oct 11, 2008

    PLEASE HELP...I was told a simalar cost to fix my HL P5663W 62", and that I needed to replace a video card which costs $750 through bizrate.com + additional labor cost's. So far I have not been able to find any information that confirms this. PLEASE HELP...

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 252 Answers

Check the horizontal transistor if, good.re solder your tv.

Posted on Oct 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Samsung model hlt4675sx\xaa projection tv wont work. the stand by/temp light flashes red and the lamp light flashes green? it makes the sound that it makes when it turns on but no picture. we looked at the...


It could be the temp sensor going bad. This sensor sits on top of the metal housing which the bulb assembly slides into. The bulb assembly will have a hole on top and this is where the sensor is above. There is a small blue and white wire that plugs into it. If you pull the wire out and put a paper clip or wire in the coupling you will basically bypass the sensor connecting the blue and white wire. If your tv turns on then that is your problem. Its cheap too. Here were my symptoms..1] Turn tv on 2] Bulb would light up..(which eliminates the ballast) regular picture would show up (which eliminates the bulb and color wheel) 3] 30 seconds later tv would shut down with 3 flashing lights. After bypass the tv turned on as always and hasnt shut down yet. Always un plug tv first. Get the replacement part to avoid overheating and possible fire

Jul 31, 2011 | Samsung DLP HL-P5663W 56" TV

1 Answer

I have a samsung 50 inch dlp. not sure what model number. it turns on and off automatically while pluged in. the display lighs blink simutamiously. please help


One of the display blinking lights?It said bulb or lamp?If yes,ur projection bulb need it replaced,it life exspan,it over.It require a new projection bulb.

Apr 28, 2010 | Samsung DLP HL-P5663W 56" TV

1 Answer

NO POWER


If there is no standby light or any blinking LED lights, check the outlet first to make sure you are getting power. If so, then the power supply board in the TV has failed. If you are getting blinks and just no picture or sound, it will be something else depending the sequence of blinks.

If you are getting blinks, I would check the lamp first. This is the most common failure. Look for either a cloud near the stem of the bulb or if it is shattered, replace the lamp.

Oct 07, 2009 | Samsung DLP HL-P5663W 56" TV

2 Answers

Our Samsung HL-P4663W DLP is makes noise and shuts off


It is the color wheel, inside the light engine. The bearings get dirty and makes it harder for the wheel to spin causing that whin.

Jan 06, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

Samsung dlp model hl- S5086W making continious humming noise, has nothing to do with volume. Can I replace fan or wheel myself?


Most likely color wheel since most are defective right out of the factory--- someone has a step by step procedure to replace with pictures-- try google- samsung colorwheel -- fun job easy to do!!!

Jan 04, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

50? Samsung DLP TV Model #HLR-5067W


Did you use an original replacement lamp or an aftermarket replacement? From the price you give, it sounds like an aftermarket lamp, which are notoriously buggy and the problem may be with the lamp. If not, the lamp driver is your next likely culprit. It is also called a lamp power supply or lamp ballast.

Oct 19, 2008 | Samsung DLP HL-P5663W 56" TV

1 Answer

Samsung DLP HL-R-5667W lamp LED comes on solid, no picture, then turns off


DO you have the owners mannel if so read it and see what they would do ,have you removed the lamp and if so how did it look? some lamps only last for 5,000 hrs and others 8,000 hrs If lamp is bad TV will not come on.

Feb 20, 2008 | Samsung DLP HL-P5663W 56" TV

Not finding what you are looking for?
Samsung DLP HL-P5663W 56" TV Logo

Related Topics:

426 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68223 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

Are you a Samsung Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...