Question about Projection Televisions

1 Answer

My Tv is flashing blue red and green when i turn it on

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,712 Answers

You will need to replace the convergence IC's. Looks like they are going bad. Replace both and not just one. They are not too expensive to buy, but if you have no prior experience in electronics, I suggest leaving this to a qualified service man..

Posted on Sep 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi. My Sony Videoscope XBR's Convergence Allignment


I happen to share this same problem. The alignment of the gridlines on the standard convergence panel are completely abnormal, and if I attempt to auto-adjust the TV, it flashes different colors on the sides of the screen , and then turns off the convergence settings.

Feb 01, 2010 | Sony Projection Televisions

1 Answer

Sony kp-57ws500 flashes blue, green, red then turns off


Re-insering the flyback wire is usually very easy. Push in and give a slght turn and check to see if grabbed. It sounds as if there is more issues than flyback wire. TV should turn on without one crt connected

Dec 14, 2009 | Sony KP-57WS500 57" Rear Projection...

1 Answer

I was getting nine flashes and know the green crt


Sounds like a bad green crt. These Sonys are bad about that.

Jul 06, 2009 | Sony KP-65WS500 65" Rear Projection...

1 Answer

5 flashing light code


Disconnect RED Tube CRT board if set plays without shuting off RED tube is bad or video IC on CRT is bad.

Feb 12, 2009 | Sony KP-51HW40 51" Rear Projection...

1 Answer

Turns green and shuts off


I had an electrician come over. He pulled out the bulb that was dead (for me it was the color that was flashing before it would turn off) and now I have a blue and green TV with no red. He said that the only way to fix it is to replace the red lamp with a new one.

Jan 16, 2009 | Sony KP-65WS500 65" Rear Projection...

1 Answer

KP-51HW-40 FLASES BLUE ,RED, GREEN


Your picture tubes are trying to short out you have 3 red, green ,blue.

Mar 26, 2008 | Sony KP-51HW40 51" Rear Projection...

1 Answer

Sony kp41s3u - blue screen


Convergence amp ic bad or loose connection on ic's

http://www.techlore.com/blog/entry/19694/Sony-Convergence-Repair-My-Sony-TV-has-a-distorted-picture-/


Feb 26, 2008 | Projection Televisions

3 Answers

My TV has blue lines,flashes then turns off


Bad blue CRT common problem.....................T.

Nov 09, 2007 | Sony KP-51HW40 51" Rear Projection...

1 Answer

TV Problem with shutting off by itself


Mine just did the same thing.  Except for it was green instead of blue.  The service manual states 8 flashes from the light stands for an overvoltage.  After reading the manual for a bit I realized the bottom row of 3 adjuster screws from behind the speaker grill adjust the output for the red, green, and blue colors.  BEFORE OPENING ANY TV OR MONITOR PLEASE KNOW THAT THE VOLTAGE INSIDE CAN KILL YOU EVEN IF UN-PLUGGED so please be careful and only adjust what is mentioned here.  I un-plugged the tv, removed the grill and the board covering the internals, and carefully turned the 3 adjustment screws all the way down.  I then waited about 10 minutes (don't know if this made a difference).  I turned on the tv, turned the channel to an auxilary input (for a black screen), and slowly raised each of the 3 bottom screws one by one up clockwise until i could see a faint green, blue, or red line (depending on the screw), and then turned each one back a hair until the screen was black again.  Only adjust one at a time, the order for colors are blue, green, then red from the left.  I hope this fixes your problems.  Be careful when working inside a tv,  I suggest not using a screw driver to adjust the screws due to the possibility of it slipping and someone getting hurt.

Sep 16, 2007 | Sony KP-51WS500 51" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

60867 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...