Question about Mitsubishi WS-55819 55" Rear Projection Television

1 Answer

My Mitsubishi Medallion tv stays on for about 10 minutes and then shuts down and won't turn back on until a period of time has passed. It is a rear projection tv about 9 years old. Can anyone help ex

Posted by on

  • 3 more comments 
  • Dee Fox Nov 21, 2011

    The light blinked one time then two times. Meaning??

  • Dee Fox Nov 30, 2011

    I unplugged the tv and then tried again. Now it blinks 2 times and then 2 more times. Meaning?
    Thanks for helping.

  • Dee Fox Dec 02, 2011

    Where can I purchase the parts and how do I get the instructions?

  • Dee Fox Dec 05, 2011

    Thanks for trying. I will buy the parts and go from there or hire someone to do the repair. At least I have some idea of what the problem probably is.

  • anthony mazzola Feb 16, 2013

    can i get the instructions please

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 49 Answers

When it shuts off and the green power light goes off, press both the menu and input buttons on the front of the set (not the remote) and hold both for about five seconds and release.

Power light will blink a two digit error code like 2 blinks and then 3 blinks and repeat it several times.

What is the error code?

Posted on Nov 16, 2011

  • 6 more comments 
  • Steve Jones Nov 22, 2011

    It means no error found, if you had unplugged the set it clears the error buffer, if so plug in and try to turn set on again and perform test again.

  • Steve Jones Dec 02, 2011

    2,2 is short protection--98% chance one of the pico fuses that protect the convergence circuit are blown, depending on actual model number set uses either or or two chips---pretty straight forward repair---parts cost under 25 dollars, and I happen to have start to finish instructions for this repair in most Mitsubishi models.

  • Steve Jones Dec 03, 2011

    As for the instructions I have them (they are from a friend who has repaired as I have hundreds of these sets) Give me a email address and I will forward them to you--if posted here others will copy them for free.

    Best place for the parts is Suburban Electronics---they have internet catalog and the instructions tell you what you will need------if the model is WS-55819 IT WILL USE TWO of the stk-392-570 chips and I have photos of the board--if 2,2 there are also two pico fuses and one or both are bad as well.

    Once you get the instructions you will know if you can do the repair.

    They are very detailed.


    Reply as soon as you can as this site may soon shut down completely.

  • Steve Jones Dec 03, 2011

    http://www.suburban-electronics.com/prod...

  • Dee Fox Dec 03, 2011

    My email address is Deeleefox@aol.com. Thank you so much for your help. It is greatly appreciated.

  • Steve Jones Dec 04, 2011

    that email does not work at all from here, sorry

  • scott_craib
    scott_craib Nov 17, 2012

    What does the error code stand for, mine blinked 2 times, then 2 times again. not three

  • scott_craib
    scott_craib Nov 17, 2012

    what does the blinking stand for? Mine blinked two times, then two times, then stopped. Also mine shuts off in a matter of seconds not minuets.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I am having a problem with my Mitsubishi medallion HD1080 . I turn it on and it turns off right away. It won't stay on for 3 seconds shuts off by its self. Can somebody help me?


Hello,

It's the problem of overheating in the power supply board of the TV.on the power supply board of the tv there are few capacitors and IC.any of this ic is got short or may be weak.so due to this when you start the TV the current passes from electric outlet to the power supply board of TV.but when the current passes from that weak/faulty part at that time current gets stopped or slow and the board overheats and TV shuts off. this is a common problem faced by many other users too.the possible option to solve this issue is to check the power supply board by a meter and continuity tester and replace the faulty component on the board which is short due to which power supply board is getting overheated.its bit technical job but yes its not at all a costly repair to do or get it done by the technician. for required parts it can be easily available from local electronic hardware shop.

Hope this will helpout...

May 17, 2011 | Mitsubishi Televison & Video

1 Answer

Mitsubishi 65" LCD (1080P, DLP) keeps shutting down until it "warms up". After shutting down the power led flashes yellow for a minute or so, at which time I power it up again. This cycle repeats 1 to 4...


Try connecting the TV directly to a different wall outlet and check. If the issue persists, try power resetting the TV. Turn Off the TV and remove the power plug from the wall outlet for 1 minute and reconnect it and check the operation. If the issue persists, then the TV may require service.

Jul 27, 2010 | Mitsubishi LT-40133 40 in. LCD HDTV

1 Answer

I have a 55 inch Mitsubishi medallion 1080i and it will just shut off however the green power light stays on..I've reset it a couple of times and I can turn the tv back on and sometimes the screen is blue...


I had the same exact problems. So before you go poay a repair person $800 to tell you it is the capacitors. It is simple to repair yourself. Total repair costs will be abouyt $60-$80 plus the time it takes which it took me approximately 2 hours. Now I am good with computers and electronics overall but I looked the how to reapirs up online and it was quite straight forward without any exstensive issue causing work. The main thing is rounding up the capacitors which in my case were found at radio shack as well as all the other items you need. To find out the details on repairs you need to type in "how to replace 55 inch mitsubishi medallion 1080i capacitors. I dont have the details or web page I used still around to referencew you to or i most certainly would. Hope this helps.

Jan 17, 2010 | Televison & Video

1 Answer

Mitsubishi Medallion rear projection lost signal from all devices


Have you fixed this problem yet?. I seem to have the same issue.

Sep 07, 2009 | Mitsubishi WS-55513 55" Rear Projection...

1 Answer

Pioneer SD-P62A3 62" shuts off - won't stay on


If this TV turns back only when it is cooled down than it has cold solder joints tha have to be resolderd.

Jul 07, 2009 | Mitsubishi VS-6055 60" Rear Projection...

3 Answers

Mitsubishi 50inch TV Turns off right after I turn it on


tv is in shut down.could be several things.call a repairman.

May 10, 2009 | Mitsubishi VS-50501 50" Rear Projection...

1 Answer

Projection TV keeps shutting down


Good Day;

Sounds like you have a bad green picture tube that has failed. To check this out; remove front speaker grill, remove small panel, you will see three CRT's (pictue tubes) sticking down, remove the little board on the middle tube then restore power. If TV stays on more then likely the CRT is bad but not always the driver on board could also be bad, check voltages.

Good Luck, big IRISH.

Sep 05, 2008 | Mitsubishi VS-45607 45" Rear Projection...

2 Answers

Mitsubishi VS-50707 shuts down sporadically


you can do a self-diagnosis test by pressing the menu and input/device button on set for 5 sec and see what error code it gives you. Count the blinks followed by a short pause then more blinks. This is the error code.

Mar 10, 2008 | Mitsubishi VS-50707 50" Rear Projection...

2 Answers

Projection TV keeps shutting down


I just took my Mitsubishi WS-65315 65" in to be repaired for the same problem and was told that it needed a new main circuit board part number 930b899005 as was told they wanted to charge me $1100.00. So I told them not to do the repair and picked up my tv and found that same part at Sears parts for only $225.00. Some of these TV repair places are theifs.

May 10, 2007 | Mitsubishi WS-48315 48" Rear Projection...

Not finding what you are looking for?
Mitsubishi WS-55819 55" Rear Projection Television Logo

607 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1255 Answers

The Knight
The Knight

Level 3 Expert

76069 Answers

Jaime Hernandez

Level 3 Expert

2337 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...