Question about Coffee Makers & Espresso Machines

1 Answer

Need cord for coffee urn perculator manufactured by consolidated silver co.

115 volts; prongs on urn are 5/8" apart, measuring center to center.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 5,568 Answers

This sounds a lot like a standard high-power AC cord and any hardware store should carry these.

Posted on Sep 28, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a Magic chef MCWC50DST that the compressor and fan wont start. I thought it was the ptc starter which I replaced and that didn't fix it. The circuit board and controller are getting power as the light...


are u saying u replaced the start relay? and capacitor? I would check the cold control thermostat as if its defective u will get no fan no compressor etc. u can also check the compressor itself by removing the relay and capacitor then using a multi meter to measure the run and start windings for ohms, measure separately then together and the reading u get when together should equal the readings of both separate measurements? give or take 5 percent. u test by connecting the multimeter prongs to the nutual and the run and the nutrul ( center prong) and the start prongs

Mar 12, 2015 | Magic Chef Refrigerators

1 Answer

45 cup coffee urn How much water and how much coffee?


20 cups of coffee needs 2 cups of coffee grounds
30 cups of coffee needs 2 1/2 cups if grounds
40 cups of coffee needs 3 cups of grounds
45 cups of coffee needs 3 1/2 cups of grounds

1 cup brewed coffee = 5 fluid ounces
* use standard measuring cups

Oct 22, 2010 | Salton Melitta MEU45 Stainless Steel -...

2 Answers

Need extra cord for my 42 cup hamilton beach coffee urn


I just called the company and ordered the lid for 10 dollars and change. they will also send me a manual so I would thing you could get a cord too

Aug 09, 2010 | Hamilton Beach GE 42-Cup Coffee Urn Coffee...

1 Answer

Brew light does'nt go on and water doesn't heat up and water doesn't come out


Possible bad switch or bad power cord. Remove the bottom plate and look for ~115 volts AC at the ends of the power cord with a voltmeter (cord plugged in). Make sure the outlet has power where plugged in. If you get voltage, then turn the switch on and measure the voltage across the switch terminals. If it reads 115 volts, replace the switch. Good luck!

Mar 15, 2010 | Anvil CMA7001 Coffee Maker

1 Answer

2001 7.3 where does the 115 votes come from i hve on one head but not the other.


Are you talking about 115 volts? What are votes? That's probably why no one has an answer for you because you didn't proofread what you wrote. I'll give it a shot. The only place on an F-250 to have 115 VOLTS would be the engine block heater on the 7.3 diesel engine. The plug is located behind the front bumper a little bit off center to the drivers side. The plug prongs have a moulded rubber cap over the plug.Hope this helps.

Jan 18, 2010 | 1996 Ford F250 Crew Cab

2 Answers

Wire Hayward Super Pump for 115


If you look closely, you should see a small arrow on the black plastic piece on the terminal block(jumper). That arrow lines up with either the 115 or 230 mark on the white terminal board. Make sure it is aligned with the 115.

Then put you two line wires on. It does not matter which wire goes to line 1 and line 2, just be sure you DO NOT put them both on the same terminal. A plastic divider usually seperates the two line connection terminals.

Jun 13, 2009 | Hayward SUPERPUMP 2.0 HP, 115/230V

1 Answer

Need replacement cord FEMALE GE Heat 'N Serve Baby Dish model D-3


may have to buy parts and build your own extension cord! home depot or lowes, or ace should have what you need!

May 28, 2009 | Sephra Elite Chocolate Fondue Fountain

1 Answer

10-22 urn


If you have the L1350/155C, the manual states 1-1/4 cups coffee for 12 (5 oz) cups, for 30 cups use 3 cups coffee using standard measuring cups. Take the stem & filter out when the coffee has finished brewing so the bitter oils do not get into the coffee.

Dec 17, 2008 | Faberware 10-22 Cup Coffee Urn

2 Answers

Rival cf153 wm


Hi , you may bring power to the appliance center for comfaring the most fit poer cord and durable.

Sep 05, 2007 | Rival CF153-WM Deep Fryer

Not finding what you are looking for?
Coffee Makers & Espresso Machines Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Coffee Makers & Espresso Machines Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

yadayada
yadayada

Level 3 Expert

69199 Answers

Kolbrun...

Level 3 Expert

1194 Answers

Are you a Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...