Skyscan model 88900 atomic clock

Hi,
The transmitter for your radio controlled clock is the atomic clock in your region, I wouldn't advise trying to replace the batteries in it.
I am guessing you are talking about a remote wireless sensor supplied with your clock! Put good quality batteries in this and place it next to your receiver (your clock) while it registers and then you can place it outside or wherever you want it.

Go to link for the manual.... http://skyscan.info/content/manuals/25-model-88900.html

Are you getting a signal? The disp Ay should show that it is picking up radio time signal on the display. If not, reposition to a totally different location. If still no signal, receiver must be off. May be warranty issue.

taking the batterys out and leaving them out for 60 seconds or more will in effect reset the clock. Put the new batteries in and wait for the skyscan to detect the outside temperature (if this unit has a outside sender). after this show on the screen push the button that corresponds to your time zone. You can now set the clock with the push buttons or take the clock to a wall that faceing? ( you don't say where you are located), the WMV signalyou need to set the clockto is coming from Colorado USA ( if your in the us) so make sure the back of the clock is facing toward colorado. let the clock sit overnight as the best signal will be recieved when its dark and especially in the very early morning, just before sunrise. this should automatically set the clock for you. good luck

Hello.<br /> Thank you for contacting FixYa.<br /> You should be able to find instructions here!<br /> <a href="http://www.atomicclocksstore.com/skyscan-atomic-clock-model-81690-manual">http://www.atomicclocksstore.com/skyscan-atomic-clock-model-81690-manual</a><br /> Best regards.

For Models 88900/901 TX in a battery symbol is the Low battery indicator (Sensor)
RX in a battery symbol is Low battery indicator (atomic clock)
Source: Page 4 of the manual.

I have a skyscan Atomic clock model no 86730 and can't set it, every time i get it set, it goes back 1 hr, i need to know to set it to daylight savings time

This is a very common problem that is most frequently caused by the outdoor transmitter going bad. They are surprisingly delicate and don't like getting wet.

You can order replacement transmitters from http://skyscan.info/content/

They only cost $11 and that includes shipping and handling.

figure out where yu are north south west east zones on your map from where yu are , then pull battery again it should stop at for eight or twelve push time zone then set in a window facing your zone it should automatically pick it up shortly in awhile
sw i think it may stop at four also but then wait

You need new SioScan Temperature Transmitter 433 MHz. Take a look on amazon La Crosse Technology TX6U Wireless Temperature Sensor for 433 MHz units.... Hope this was helpful. cheers