Question about Bugaboo Frog Stroller

1 Answer

The buggy board popped off and I need to put it back on, but I missed place the directions

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Governor:

    An expert whose answer got voted for 20 times.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 13 Answers

Leave your (bassinet or seat) on the stroller, then flip your stroller frontward and then put your clips on the push them until they cover the silver screws and then the wheelboard has to hug the bar for it to grab on ( don't forget to put on the elastic with the velcro on and velcro it to the bar right on top of the wheelboard.. Hope it hepls if you need more info you can e-mail me at bugabooexperts@yahoo.com
Thanks, Nathalie

Posted on Dec 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you fit a buggy board to a quinny zapp xtra?


Hi

We would not recommend it.

The Zapp Xtra is a lightweight, short wheel base chassis and the addition of a buggy board may make it unstable and likely to tip. In addition please remember the maximum weight limit for the Zapp Xtra and do not exceed this with the combined weight of the 2 children. If you choose to use a buggy board Quinny do not accept responsibility for the performance of the Zapp Xtra or any damage done to the chassis caused by the buggy board.

Jul 16, 2012 | Quinny Zapp Xtra Travel System Stroller

1 Answer

I HAVE DIFFICULTY GETTING THE BUGGY TO GO FLAT. iN THE SHOP THE LADY PULLED A CLIP. i PULL THE CLIP AND NOTHING HAPPENS.


Eileen,

Thank you for asking me directly to help you with your problem. However, either the question you are asking is not within my area of expertise (I am an automotive repair technician), or the question is incomplete and does not contain enough information for me to help you.

Dec 31, 2011 | Silver Cross 3D Stroller

1 Answer

When we put our child in the buggy seat the whole frame starts to sink down like its closing without any of the buttons being pressed. Can this be fixed?


hi were the grey button is to fold pram down,you have a black cover on the owt side,these pop off,inside there is a spring ! you need to pop the spring back in,easy to do,kept doing this to mine,but is a common fault with these prams,try that and see how you go,hope this helps caroline

Jul 10, 2011 | Quinny Buzz 4 Storm Stroller

1 Answer

Need to buy a replacment hood for a bebecar buggy. Where can i buy it.


Your best bet would be to pop into your local Bebecar retailer (find it here: http://www.bebecar.co.uk/stockists/stockists.htm ) or contact Bebecar's spares dept. directly at service@bebecar.co.uk. Unless you know the name of your fabric, you'd be advised to either bring your buggy in or to provide a photo of it, in order to find suitable fabric match.

Jun 14, 2010 | Baby Strollers

1 Answer

Putting up the double buggy


COS THIS IS THE DOUBLE 1, YOU NEED TO TREAT IT LIKE A SINGLE....
IF YOU STAND BEHIND THE BUGGY.... ON MIDDLE QUITE LOW DOWN ON EACH OF THE BUGGIES, THERE SHOULD BE LIKE A LITTLE PLASTIC BIT. APPLY SOME FORCE WITH YOUR FOOT ON EACH OF THOSE UNTILL IT CLICKS IN PLACE...

THERE YOU GO :)

YOU CAN ALSO VIST: WWW.MACLARENBABY.COM ON THERE IT WILL SHOW YOU EXACTLY JUST HOW TO DO IT :)

Jul 14, 2009 | Maclaren 2009 Twin Techno Double Stroller...

2 Answers

Need to buy a new hood for a silver cross buggy pop? Is this possible?


hi kirstybrown1...here's a link for silver cross where you can email themabout the spare part or contact the retailer where you bought yourstroller..hope this helps.please let me know the outcome..good luck!!

https://www.silvercross.co.uk/contact/spare-parts/

May 02, 2009 | Baby Strollers

2 Answers

Phill and Ted pram hood hard to put back in place


Hi,
I have the same problem with a Phil and Ted's Sport - but I believe I have the solution as below. This is taken straight from the Instruction Manual which you can view at: http://www.arango-design.com/Phil-Teds-Sport-Buggy-p/7890-0001.htm - towards bottom of page is a link to the instruction manual - which I was unable to get on the Phil and Teds website. Got this today but haven't tried it yet. Hope this helps.
Really becomes clear when you see the pictures in the instruction manual.
Regards, John
Hood
The sport hood is packed disconnected.
To reconnect:
1. Locate sun hood and hold it facing down, as shown ‘a’.
2. Insert crimped wire ends into frame, through eyelets, ‘b’.
3. Lay hood back (to top of buggy).
4. Locate red coloured pocket at top of fabric seat and insert rear hood wires into each side, ‘c’ and ‘d’.
5.Open hood and attach domes, at bottom of hood, to main seat, ‘e’.
6. Pull eyelet at top of hood over pegs on each side of frame, ‘f’
Note that the windows in the hood are lined with a sun mesh of
a lower shade factor than buggy fabric. Always use sun cream
and clothing for protection of children in direct sunlight.

Nov 12, 2008 | Phil & Teds E3 Jogger

1 Answer

Quinny zapp bar keeps dropping


It sounds like you put too much weight on the back of the buggy - handles at some point.
This happened mine too. it clcks into place but it doent stay up.
I looked intogetting it repaired but it cost too much - in myopinion

Jul 25, 2008 | Quinny ZAPP Stroller

Not finding what you are looking for?
Bugaboo Frog Stroller Logo

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Bugaboo Baby Strollers Experts

Stephen Faulkner
Stephen Faulkner

Level 2 Expert

541 Answers

Jennifer Rock
Jennifer Rock

Level 2 Expert

105 Answers

J.D. Browning
J.D. Browning

Level 3 Expert

2621 Answers

Are you a Bugaboo Baby Stroller Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...