I need a wiring diagram for my Hewitt package computer

https://www.modifiedlife.com/2004-chevrolet-avalanche-car-audio-wiring-diagram/

Herewith picture for 7 pin connector

There is a one page diagram here:

http://h10032.www1.hp.com/ctg/Manual/c00757455.pdf

For an explanation of the icons you may need to refer to the Getting Started Guide here:

http://h10032.www1.hp.com/ctg/Manual/c00757455.pdf

it costs 12 bucks for the plug and wiring harness at wall mart for chryler/ jeep.with the wiring harness instructions are on or in the package.u will need the plug if you are useing the factory speakers and factory wiring in jeep for power.if not just copy the instructions off the package.it will give you all you need to know,just match them up.and you should be all set/MAKE SURE YOU RECHECK ALL WIRING 2 OR 3 TIMES BEFORE PLUGING IN.

http://www.ownersmanualsource.com/chevrolet/chevrolet-impala-owners-manuals/
Thank you for using fixya

FSM Forums • View topic - Hitachi Air Conditioner ManualsHitachi Air Conditioner Manuals - looking for Operations & Maintenance Manuals, ... RUA 30AT3S (Package 30 Tons) RUA10AT3S (Package 10 tons) ...
www.manual-directory.com/forum/viewtopic.php?f=10&t=2453...0 Hi, although your unit is a 2 1/2 ton, you will be able to get a manual showing you the correct wiring diagram using the model number you supplied. It shows your model above. This is the only way to get a diagram for this unit. Please keep me posted on the out come or if you need more help.
Sincerely,
Shastalaker7

impossible to get wiring diagram without model or manufacturer

I assume you know if this is correct voltage and single or 3 phase, and whether it will fit your application or not, how is the duct work going to attach, how many people will be in the conditioned area, what is the building made of, how much insulation is has...

A little more to it than just "turn it on".


If you get the models and serial and can contact the manufacturer or their representative you might get a wire diagram. Most any package unit would do. As long as you keep the original equipment controls. If you "patch" it up it may be hazardous by not having safety's where it was designed for. Or for instance It may have a anti freeze thermostat. By passing this could lead to coil freeze up and compressor damage. Leaving out a pressure switch (if any) may do the same or could become dangerous to people in the event of fan motor failure. A low temperature fan speed switch may not be needed now unless you plan to run the AC in below 55'f.
And a few dozen other factors that might need to be considered.


If you feel confident after this then contact carrier.

Please rate me as high as you can and thanks for using fixya.

check the capicitor if it is domed up on top bad check the wires at the compressor to see if burnt take a insulated object and bump the contactor in to see if comp starts if so then out on low voltage circ check for call from stat on common to yellow then follow the connections may be out on low psi switch located in the suction line

Hi there;

Here is the wiring diagram for the trailer wiring for your truck.

Hope this helps
Farrout!