How to use and set temp for dry mode on panasonic split system

in the heat mode the fan mode run automatically first in low mode and after a while it run normally ,how you set on the remote.if you can-t set on the remote is possible to have problem to the remote.

I have the same model. It works brilliantly as we tend to dry the washing inside this time of year. When on dry mode try turning the "set temp" down to 17'c this normally starts mine off,,, failing that put some washing in a warm room with the dehumidifier "temp set" at 17'c just to test it maybe. or perhaps its just not humid enough where you are placing it? Good luck.

Dear friend, find below symbols for mode setting. For cool keep minimum 3 degree less than room temp and heat keep minimum 3 degree higher than room temp. Dry mode will help you only in wintertime. Thanks.
Now symbols:
1. fan leaves - Fan only
2. Rain drop- Dry mode
3. Snow flake-Cool mode
4. Sun- Heat
5. A or AU- Auto mode.Helpful?

Press on/offf in your remote. You keep any mode -blower will start first. But only dry and auto mode the fan speed will be low only. You can't change speeds

Fan mode only, you can control low/med/high speed. In dry mode with low fan, it cut in and off air-con for five minutes frequently.

By pressing on/off switch on .And then press mode button FAN,DRY,COOL,HEAT & AUTO as you required.
Cool position keeps 22 degrewe by clicking
Heat position keeps +29 by clicking
Auto will be 24 degree and you can't change temp and also fan speed.
By clicking Fan you can choose LOW,MED,HIGH.
Hope this will be helpful?

When dehumidification operation is set by remote controller,the intake air temp.is detected and the setting temp.is automatically set according to intake air temp. expl. Intake temp.78.8 set point will be 77. When intake air temp.is 2deg.below the setting temp.the indoor fan operates at iow speed or stops.It is just a way to controlle humitity rater than just temp.Some systems reach setpoint before enough humitity is removed,making house feel stuffy,or damp.

On the remote, press the mode button (might also be labelled master control) until a snow flake appears. Then set the temperature for 23 degrees. The speed of the fan can be changed by the fan button. All functions should cycle through so if you go too far, just keep pressing the button until you get back to the desired setting.

that's normal

There is a sensor on the indoor coil that needs to reach a certain temp before the fan speed will increase. Sounds like the unit is undercharged if the sensor isn't reaching the temp it needs to.