I need a manual for marantz tt 530

http://www.ebay.com/itm/Original-Marantz-TT-153-rubber-feet-for-turntable-/231160976533?pt=Vintage_Electronics_R2&hash=item35d2449495

The needle skipping is caused by (A) a worn stylus. (B) not enough pressure. Which is solved by adjusting the weight on the end of the arm. It can only really be solved by trial and error. You increase the weight slightly, then play the record. You keep doing this till the record stays in the grooves but doesn't make a rumble sound. If it starts to rumble reduce the weight.

I have one and it's manual, coould scan and send to you if youwish, I am also looking for a replacemet tonearm for my 330, anyone know of one?

Could certainly be a broken belt. Lift record tray and look to see if belt has fallen off or has basically fell apart. Belts can be purchased at Marantz.com. If no belt could be a bad motor. Same website.

My Marantz 6110 wasn't working right. I had it repaired at a stereo store. They told me the grease was old and had hardened which made it difficult to operate the way it was supposed to. They cleaned it and used new grease. It's been working great for the last 10 years. I hope this helps.

hi,
replace all the electrolytic capacitors in the circuit board. if its value changes this type of problem can occur.
ok

I have same problem - can't move platter at all - but need to replace belt

http://www.retrevo.com/support/Marantz-TT-15S1-Amps-manual/id/511dj893/t/2/

Just register and it's free.

Hi go to marantz web at www.marantz.com.

All manuals available there

Good luck

http://www.archive.org/details/Turntable_Belt_Installation

above is a generic video that applies to almost all belt driven turntables including yours that will show how to install the belt and a few other things. the website shown in the video lists your belt under the "find my player" button on the left side of that site.