Manual laser jet 4

HP LASER PRINTER 2300 ERROR 52.X


1. A temporary scanner start up error.


2. This can also be the shutter tab on the print cartridge. Replace the toner cartridge.


3. Replace the scanner ***'y.


4. Replace the engine board.


Tallon41

While there are many ways to prevent Brother printer error code "41

While there are many ways to prevent Brother printer error code "41

900 Error Code service check

1 Printer POR
Turn the printer off and on several times. If Error Code 900 continues
to display, go to step 2.

2 System board
Make sure the system board is properly seated in connector J7 on
the interconnect board.
Turn the machine off and on several times, waiting a few minutes
between power on and power off.
If Error Code 900 continues to display, go to step 3.

3 Factory defaults
Restore factory defaults. See “Restore EP Factory Defaults” on
page 3-18. This resets the non-critical areas of the user NVRAM. If
Error Code 900 continues to display, go to step 4.

4 Sub error codes
With Error Code 900 displayed, press Select and Return. Record the
complete list of Sub Error Codes on the display. Check the “Base
printer sub error codes” on page 2-6. If none of the Sub Error
Codes are listed, then call your next level of support.

From page 2-41 of IBM's service Guide

A 52 error is a Scanner failure. Do you hear a "whirring" sound when you get the error?

That's the sound of the scanner motor running amuck.

You're probably going to have to replace the Laser/Scanner assembly or the DC Controller which controls the Laser/scanner motor.

The c1300 error means that the Laser Printer needs a new Laser Unit. Unfortunately, it will have to be serviced/replaced.

I hope this helps :)

Best Regards,

James

Error code 41, Print cartridge is bad and gone out. Needs to be replaced by authorize dealer for just under $100.00 ($55.00 part & $40.00 Labor).