Question about Toshiba 32AF42 32" TV

1 Answer

No sound this is a tv that is at least 5 yr old turn on no sound. good pitcher voumel control works but st9ill no sound.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,071 Answers


NO Sound
First check to make sure there isn't a mute switch or switched to external speakers, then
use ohmmeter to measure the speaker resistance (3ohm to 30ohm is usual).

Now find the speaker wires, and follow them down to the pcb, and look for a chip with
7/8 legs then measure the voltage on all of its legs, you should get 8v to 20v on one pin and half of that on one of the others, the internal circuit of most chips is that of a push/pull output stage, with the output coming from the middle of the pair of transistors.
(if there is no chip then it will actually be a transistor push/pull pair).
no sound - snd.gif

If no voltage of at least 6v then look at the pcb from each leg of the chip, and look for an electrolytic cap to earth, thats the power line,
so follow it and look for a voltage regulator or straight from power stage (PSU),
and test if voltage there.

check for fusible resistors and power diode and smoothing cap.

If voltages are ok, then when your meter (other probe hanging loose) probe touches the input pin ,a buzz from speaker should sound, if not then change chip.

if buzz occurs then your looking for the SIF chip,
so look for a three legged Xtal filter with 6mhz (5.5mhz europe) thats the chip.

Questions
Is the eeprom/micro pro set to a different country sound system ?
Is the mute line on ? micro pro control
Is the speaker switch set to internal ?
Is there power to the output chip ?
is there at least one pin (on the o/p chip)with about half the power voltage ?
Is there power to the sif chip (12v) ?
Is the tv from another country (different xtals) ?

Hope this may help you;

Regards,
VOTIT

Posted on Sep 21, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is 9 year old Fujitsu Plasmavision TV worth fixing?


Hi

Can i please know yout TV model number to assist you better.

Thanx

Jul 22, 2010 | Fujitsu Plasmavision 42" TV

1 Answer

My tv will only display ch. 2 my little 5 yr. old was playing with the settings it is a 15 yr. old zenith tv


Depending on your market, it sounds like all of the other analogue channels have been terminated (not your son's fault) in order to provide stronger HD signals. You may need to run to wallmart and get that $50 decoder box.

Apr 21, 2009 | Zenith SY2772DT TV

1 Answer

JVC i art 32" flat screen


your tv is under shutdown state, there is a protecting circuit that prevent the tv from turning on when there is a short

Sep 10, 2008 | Standard (CRT) Televisions

2 Answers

Philips TV 27PT543S37A


ctgarden girl, my set does the EXACT same thing! I too wondered if a cold room was an issue. The set is only 4 years old, and I didn't have this problem in my old place where the room was a lot warmer.

Can someone please help?!?!?!?

Jul 08, 2008 | Standard (CRT) Televisions

1 Answer

TXN2771HF (5yr old) - Front Panel a/o Remote Issue


Sounds like the 5 volt supply is low, Look for the 5 volt regulator, Measure you can go directly to the sensor 3 pins 1 will be 0 volts one will have 5 volts the other is usually a fluctuating 3-5 volts if 1 pin has to have 5 volts if it is low check capacitors around the 5 volt regulator probably 47uf to 100uf look for rusty look on the leads. If you see it change it! check these voltages with set turned off ( standby ) do not attempt if you dont know what your doing. Good luck. The reason it works when it is on is because there is a run 5 volt supplement.

Jun 20, 2008 | Samsung TXN2771HF 27" TV

1 Answer

Will not complete start up goes to stand by.


Hi,sony are good with there blink codes,try searching the net for advice on this particular code and model of tv,this could be anything from a capaciter going low in value in the tv(power supply normaly)to the tube.

Apr 20, 2008 | Sony FD Trinitron WEGA KV-34HS510 34" TV

1 Answer

My tv will not turn on


Sounds like a bad flyback transformer . Whats the model # . These are common problems with those sets . Does it click then clicks right back off ? If so this is your problem . good luck

Jan 17, 2008 | RCA F27242GY 27" TV

2 Answers

No sound from 5 yr old Toshiba


as picture is ok means 100% it is due to sound section. solution 1 check speaker &its connection or loose 2 check supply to sound section 3 check parts in sound section (resistance& capacitors). 4 check for audio ic if it is demaged.

Sep 22, 2007 | Toshiba 32AF41 32" TV

1 Answer

Intermitent power


Verify solid connection at wall outlet. Also, the front panel switches are not always making on some sets....accordianman

Jul 24, 2007 | Emerson SpongeBob SquarePants TV

Not finding what you are looking for?
Toshiba 32AF42 32" TV Logo

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toshiba Standard (CRT) Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

 Elex
Elex

Level 2 Expert

49 Answers

Cindy Wells

Level 3 Expert

4761 Answers

Are you a Toshiba Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...