I need to know where can I purchase a fuse for Behringer PMP2000 10 Channel Mixer

i dont now mach about the computers sorry

Try Mouser electronics. Their website mouser.com is easy to navigate. The will ship just the one fuse if you need it. If you know the size and type of fuse they are usually the cheapest. You can also try Radio Shack. They also carry a large selection of fuses.

Try this Behringer support:

BEHRINGER USA, Inc.
18912 North Creek Parkway, Suite 200
Bothell, WA 98011
Tel.: +1 425 672 0816
Fax: +1 425 673 7647

I just repaired a PMP3000.

A bit of warning on these. Do not let a speaker leads get pulled while powered. They can arc out the power amp causing extensive damage.

If the fuse ever blows do NOT replace the fuse as much more damage will result. Service the unit before using.

It sounds like you need just the fuse carrier...

This is as close as I can find:

http://mouser.com/ProductDetail/Schurter/62002300/?qs=sGAEpiMZZMv1TUPJeFpwblxZ%252bgbqW48rbR6t5kzh87o%3d

The only way to get exact is to go through Behringer or get an exact part number and manufacturer.

Disassembling your unit to get at the part would be a lot of work. I have repaired three of these and am familiar with the unit.

DO NOT REPLACE A FUSE if it blows. You will do additional damage to the unit internally.

When these blow, there is damage inside that must be repaired before restoring power.

To get an exact replacement fuse holder it is best to get it from Behringer parts. This one has a switch in it depending on which way the fuse carrier is inserted.

Hi,

You can download the manual by clicking this link

You'll require Adobe PDF Reader installed on your PC to view this manual. If it is not already installed on your PC, download it free from:

http://get.adobe.com/reader/

Hope this solves your problem. Thanks for using FixYa

either that or bad solder joints

Always check your cables and connectors on them to make sure the cable is good and the connectors are not loose. This sounds like a bad cable or connection between the line output of your mixer and input to your stereo.