I took apart my bissell proheat 2x steam cleaner and can't put it back together

Hi Tom. It sounds like your ProHeat may have lost prime. I understand you've done some troubleshooting, but we have a terrific FAQ that will help you with the no spray.

Here's the link: http://www.bissell.com/FAQDetail.aspx?id=1122&cid=ccsocial

it's in the handl

Similar problem still looking for a solution...
I observe that if I press down firmly on the clean tank while pulling the trigger, that it dispenses the correct volume of solution, but that's an awkward action to do while also doing the wet runs back and forth.

Hi,

Here is a tip that will give you all the information you need to fix your Bissell Proheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101

Hi,

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101

gjkklgj

I had the same problem. I took the whole thing apart and cleaned all the lines, water heater, brushes, etc. After putting it together the tools sprayed great and the side sprayers but the water tank would not allow the water out. THEN I saw this. http://www.bissell.com/FAQDetail.aspx?id=1122 and I was finally able to figure it out. So what I found out was that the water tank gasket was damage. lol

Hi,

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101

ghsgh

Hi,

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101

hjjfh

Hi,

Here is a tip that will give you all the information you need to fix your BissellProheat Vacuum Problem.

Bissell Proheat Upright Wet/Dry Vacuum Problems

heatman101

gdhdf

You can do this Jeremy just be take your time be patient and keep trying!