Question about Audio & Video Receivers

3 Answers

Behringer eurodesk mx9000 Power supply problems

Posted by on

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

After a little research I discovered that Behringer has had problems in the past with there power supplys so I replaced the faulty one and so far the problem has been solved. Our local power company has been sending to much power to our church building and that is what caused to old power supply to burn out. We are still trying to get them to take care of their issues.

Posted on Sep 20, 2008

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

We have extra power supply for BEHRINGER MX-9000. It is brand new. Never been used.
Go to www.1001hitech.com for more info.

Posted on Mar 04, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Looking for mx-9000 power supply. Are you willing to sell yours? If so how much do U want for it.
Thanks
James

Posted on Mar 05, 2009

  • Mark Schaefer Aug 13, 2012

    Hi I'm looking for a mx-9000 power supply unit. let me know if you have one for sale email Mark AT midimark DOT com

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Behringer Truth B2031A major hum in both monitors


Could be when the power outage the speaker was blown a little. If not check the wire connections.

Sep 10, 2013 | Audio & Video Receivers

1 Answer

My fuses keep blowing in my behringer mx 2442a power supply


Fuses usually blow for a good reason - because something else is wrong.
A fuse may go once if it is just a bit old but if changing a fuse twice has not solved the problem then there is some sort of electrical fault that you need to trace. It could be
  • a short circuit - maybe a crack in the insulation in the cable somewhere - most likely point is where the cable enters or exits the power supply and is subject to a lot of flexing or where it joins the coil windings inside the transformer.
  • too much equipment connected to the power supply overloading it
  • an open circuit or failed component causing- too low a resistance allowing too much current to flow
  • a cable or component somewhere in the power supply that has too high a resistance for the current to flow causing a build up of heat at the weakest point - the fuse.
Unless the fault is something obvious like a broken wire it may just be a case of replacing the power supply

Feb 27, 2011 | Audio & Video Receivers

1 Answer

I have purchased a behringer eurodesk 2442a, it does not have a manual, can you help?


Hi you can search for the manual from the link below for help.

behringer.com/EN/Products/2442FX.aspx#documentation

Hope it helped

Feb 18, 2011 | Audio & Video Receivers

1 Answer

The fuse and fuse holder fell out of my behringer euro power pmp2000 amp where can i get a new fuse holder


try googling the brand name to find the manufacturer, they'll have the fuse and holder. you can also try going to an electronics supply house, they'll be able to help you also.

Oct 08, 2010 | Audio & Video Receivers

2 Answers

Behringer Eurorack UB1202 Prongs on power supply broke off, need to find where I can get a replacement power supply. x


Hey kfc-jake

Behringer the whole world wide are pretty good on spare parts. You could get a tech to replace the plug for you. Where abouts in the world are you and I can get you hooked up?

regards
robotek

Dec 07, 2008 | Audio & Video Receivers

2 Answers

Behringer europower pmh5000 turn it on big flash and smoke came out of vent no longer works did smell hot when it was last used


The output section has shorted output transistors. The increased load on the driver section probably smoked a few capacitors and resistors. Until the unit is repaired, you won;t get anything out of it. I would figure on $25-$50 in parts for the repair plus the local labor rate.

Dan

Oct 07, 2008 | Audio & Video Receivers

Not finding what you are looking for?
Audio & Video Receivers Logo

Related Topics:

2,490 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio & Video Receivers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

68368 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Are you an Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...