92 buick skylark right side blinker does not work the bulbs are good left side works. you can here the turn signal quick blink noise when using right turn signal

There should two separate bulbs for marker and blinker. It sounds like a bulb is burnt out, bad ground, melted socket or a wiring anomaly. Are you certain it's supposed to have 57 series dual element bulbs for blinker and markers?

Try removing all the bulbs and ckean them and the sockets they may not be making good contact..if this doesn't do it..have someone check for a ground in the system..sometimes a ground will overload the flasher itself and close and open quicker due to the ground..good luck.

What you speak of as to the left blinker doesn't flash, yet the instrument cluster shows the green arrow (to the left), and yet that and the left turn signal lights do not flash, appears to be a simple burned out bulb. If one of your left turn signal bulbs are burnt out, then the #552 Flasher Unit in your fuse box is NOT the cause. It's the "Amperage" not being correct to the flasher unit. Place the parking brake on and start your vehicle. Put the left turn signal on and check to see ALL the bulbs are illuminated for the left turn signal. If you find one bulb that is not illuminated, then replace the bulb. It should be an 1157 bulb, but in the front it could be a 1157 Amber bulb dependent on whether your turn signal lens is clear or yellow.

If you still have difficulty finding the dead bulb, turn on the right turn signal and see which bulbs are illuminated and this will give you an idea as to which bulb on the left side isn't working, or turn on your Emergency Flashers which will turn on both the left and right side lamps and see which bulb is not lit up.

I hope this Helps,

~00 Buck~

"Still living on the Right Side of Dirt..."

Usually a fast turn signal means that there is a light out. You should probably check all of your lights, including back-up lights, and turn signals. If there is one out then replacing the burnt out bulb should fix the problem.

If ALL Wiring in Trunk is Good Then Its The SWITCH = Multifunction Switch<<

I know this will sound Stupid. Get back inside to the Bulb that you Replaced and Turn it Over. Some of these Bulbs will only work if they are in a Certain way. Have that Side Blinker Going when you are Messing with the Bulb to Minimize the Work load on thisPlease Rate my Response, I need all the Help That I can Get! Thanks! Job.

You did not say if the right signal blinks ok or not. Assuming it blinks like the left, the best way to find the blinker is to leave the engine off but the key switch on and turn your blinker on. Now LISTEN and you should hear the clicking. If the right side blinker is normal then you may have a bad turn signal bulb or ground to one of the signal bulbs. An easy way to check your turn signal bulbs is to turn on your emergency flashers and look at the bulbs, they all should blink at the same time and with the same brightness. Good Luck

You have a bulb on that side that is burnt out the bright side.

The left blinker comes on, but does not blink? Either the front or rear bulb on that side is burned out (turn signal filament only). U can swap bulbs from good side to determine which is the bad bulb, or by carefully checking the bulb filament for damage. Let me know if u need more info.