Question about Indesit Kitchen Ranges

1 Answer

Grill element was corroded and not working but bottom element was working. Oven light was working. Ordered and replaced top grill element in indesit FM 20 K.C IX GB multifunction oven. Now, there is power to the clock but no power to the oven now. Oven light does not come on either. Am positive the grill element is connected correctly. Have I overlooked something?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,462 Answers

Did you reset the clock after you switched on - i suspect you have it on automatic

Posted on Sep 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a F&P Paprika range purchased second hand. It has no lower element in the oven and when attempting to bake the upper element burns the top of the food without cooking the bottom. Is this a design...


just been looking and if you are using the top that is the grill not the oven .... the oven and grill are in the same place bottom is oven top is grill.f460c0d3-6521-459d-80b5-9b83642e7906.jpg

Nov 03, 2013 | Stoves Kitchen Ranges

1 Answer

Grill is not working


Hello,
Is The small amount of heat you are getting coming from the bottom element in the top oven or is half the top Grill element working.To start with you have a double grill element and either the whole element has gone or just half the element.This is controlled by a selector switch which could be at fault or the Thermostat that controls the temperature.

Hope this helps.

Jul 07, 2010 | Electrolux Insight EKC6049X Stainless...

1 Answer

I have a whirlpool range mod rf368lxpq o replaed probe and panel still very slow to come to temp. pre heat goes to about 200 deg and then veryy slow to come up to temp and hold temp


It sounds like one of the elements are not working. There should be a concealed element in the bottom of the oven and a 'bake assist' element at the top iether seperate from the grill element or as a dual element assembly. Both of these elements should heat on bake function (not the grill element though), check for heat from both by turning bake on and feeling for heat from top and bottom. The oven requires heat from bot to get up to and maintain temp.

Hope this helps

Dec 02, 2009 | Kitchen Ranges

1 Answer

Fan working,grill gets hot but the oven doesn't


NEEDS NEW FAN HEATING ELEMENT.

ORIGINAL WENT ON MY A2 AND I REPLACED WITH A STRONGER
3 ELEMENT INSTEAD OF THE 2 ELEMENT ORIGINAL.

IT'S BEEN FINE SINCE.

May 11, 2009 | Smeg A2.5 Dual Fuel (Electric and Gas)...

1 Answer

Creda grill will not switch to oven when i shut the door


Model Number TGF334BCWF Gas Stove.....When I turn the burner on the top front right my oven is coming on without me turning the on. What is going on?

Feb 21, 2009 | Creda C362E Electric Kitchen Range

1 Answer

\do you have the electrical connection diagram for the top oven grill element for a Belling D841 cooker?


Generally, grill elements have only two connections and they go to the main power switch controlling the oven.  Usually, there is a diagram pasted on the rear panel of ovens or just inside the control panel cover.  If you think the element is bad, remove it and test it with an ohm meter.  If it is 'open' replace it.  If it is not physically damaged or shows an ohm reading, it is likely good.
If the question is the connections, cut the power and visually inspect then trace the switch with the diagram.  Look for corroded contacts where the element is plugged in.  If the unit uses a relay...electronics...those may and do fail.  Sometimes, you can get a similar replacement unit without getting a circuit board or find a rebuilder.

Dec 04, 2008 | Belling Kitchen Ranges

1 Answer

Grill element stopped working in the middle of grilling roast pork. Blown element vs fuse - don't know where to find fuse box on oven. How do you tell if the element has blown? Is it easily repairable or...


there is no fuse actually in the oven
take rear panel off oven and use a multimeter to check continuity across the grill element. can also be the grill regulator if fitted

Jun 29, 2008 | Kitchen Ranges

1 Answer

Older model - belling 356 double oven - unable to get grill to work


The microswitch on the right of the top oven is stuck in. Open the top oven door and you can see the switch on the right. It has a small black rubber cap on it. To solve this, loosen the right top and bottom screws of the brown panel and lever the white panel slightly to the right. Tighen the screws and the switch should go in and out as you push and release it. The grill will now come on when the door is open.

Apr 01, 2008 | Kitchen Ranges

1 Answer

Top oven grill brackets on Model SE553


you won't get a freebie replacement on a 3 year old oven!
i've had this problem many times and solve it by using penny washers and nuts and bolts to fasten the brackets

Dec 29, 2007 | Tricity Bendix SE454 Electric Kitchen...

2 Answers

Rangemaster Toledo 110 oven/Grill element


Hi,

How easy is it to fit a new grill element. The element on the left hand side of the grill is not working so I need to replace this. I'm just wondering if this is easy to do myself or do I need an
electrician
?
Regards
Sandra

Dec 15, 2007 | Kitchen Ranges

Not finding what you are looking for?
Kitchen Ranges Logo

Related Topics:

408 people viewed this question

Ask a Question

Usually answered in minutes!

Top Indesit Kitchen Ranges Experts

paulcarew

Level 3 Expert

1863 Answers

Owen Barnes

Level 3 Expert

835 Answers

ptpumpman

Level 3 Expert

406 Answers

Are you an Indesit Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...