Question about Washing Machines

1 Answer

My husbands hat had a red front and the dye got on his jeans. how can I get it out?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 126 Answers

YOU BEST BET IS TO GET A STAIN REMOVER FROM YOU NEAREST STORE OR HAVE IT REMOVED AT A LAUNDROMAT BY THE PEOPLE WHO DO IT BEST.GOODLUCK.MOHAMED

Posted on Sep 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Washer doesn drain completely


something is stuck in the water pump ive had same problem if its a newish machine remove the lower front cover you will see a plug remove it you get get into it there

Apr 06, 2012 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

I replaced the base assembly and completely level the machine and it still is unbalanced at the 11 mi. mark.


Is your washer a front loader because if it is then one possible solution is by putting less close. I have a front loader and when I put 8 blue jeans along with some other close. The spin cycle is violent and by removing 4 jeans, the cycle spins better and it end up balancing its self. Usually jeans soak up a lot of water, so try to put in lee close and less heavy close.

If this does not help then you might have a problem with the damper shocks (leaking) or springs (broken) if it a front loader washer.

Jan 11, 2011 | Washing Machines

1 Answer

When the washer spins with a heavier load like towels or jeans, it makes a horrible sound off and on. It sounds like something rough scraping against another rough surface. Is this something my HVAC...


Sounds like the bearings may be going out. Quick check for bad bearings: Open door, grab spin basket lip, yank on it; up and down works best. If you can get your fingers on the white plastic outer tub lip try to determine if the metal spin basket is moving independently from the outer tub in any motion other than round and round. If so you're rear bearings are becoming worn and will be especially noisy under a heavy load.

Jan 06, 2011 | Whirlpool GHW9100L Front Load Washer

2 Answers

Maytag puts holes in clothes


try to change the soap and the washing cycle to delicate,good luck

Sep 17, 2009 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Dyed washing


TRY TO USE HIGH TEMPERATURE PROGRAME LIKE COTTON PROGRAM WITH 95 DEGREE WITHOUT ANY CLOTHES AND WAIT UNTILL IT FINISH PROGRAMM , DONOT BUT ANY TYPE OF SOAP
THIS LIKE PROGRAMM FOR SELF CLEANING.
I THINK IT WILL BE GOOD !
THANKS

Jun 21, 2009 | Miele Novotronic Premier 500 Front Load...

1 Answer

Zanussi washing machine will not start cycle.


check water level device,must have in manual,or water pump filter.

Feb 16, 2009 | Zanussi FJS1225W Front Load Washer

1 Answer

Red light flashing


red light is check drain?
Clogged by something.
Could be a coin.
Use to have large coin when i was young and forgot remove from my jeans. So mum made me repair that every time. In that case filter clean, but coin bloking filter inlet.
Not necesarily coin in your case.
never buy these deals over Ebay my advice.
If you have the machine already then this is first to look for.

Nov 16, 2008 | Miele W310 Front Load Washer

Not finding what you are looking for?
Washing Machines Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...