- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Just count the number of blinks occur at one time. 14 blinks to trinitron TVs are not possible. It might be 10. If so,
Q8014 and Q8013 for shorts, leakage, or bad solder connections on the
" D" board. If the transistors are bad, check R8051 and IC8005,
also on the "D" board. If you wish to know more about blinking codes to Sony Trinitron models TVs, check this link. If it is Intermittent
problems? This is a great feature. You can also bring up these fault codes
on-screen to see a list of the problem numbers with the abbreviation of the
problem and the number of times this problem has occurred. This is slightly
different than entering the service mode. To see the diagnostic screen, press
the following buttons: Display, Channel, 5, volume Minus, ( not plus ) then
Power. This brings up a screen with a list of the problems and number of times
they have occurred. Each of the problems named, are abbreviated as,
"OCP", "OVP", "V STOP", ETC. We have repeated
them in parentheses in the text for the "Blinks" described above so
you can correlate between the diagnostic screen and the blink codes.
When fails to turn on: if you get a front LED blink of 4, 6, or 7 x, then pause, then likely power supply IC is intermittent with temperature. A lot of shops will want to replace the whole board for hundreds more, though. So ask a shop if they can fix this problem to component level 1st recommended.
If you r set is a Sony, then the standby light should be blinking a repeated pattern of blinks. Count them and post the count here along with the model number. That count will indicate the problem circuit and thus the solution to your problem.
know this isn't what you want to hear, but the problem you've
described can't be fixed with troubleshooting.
will have to be repaired. There is a part that has developed a defect
and needs to be replaced. If you're still in warranty, the TV will be
repaired at no charge to you. The warranty would likely be at least
one year from the date of purchase from the manufacturer. If you
purchased an extended service
they will repair the TV at no charge as well.
If the TV is no
longer in warranty, it will likely cost a minimum of $150 parts and
labor. This is assuming that you only need one circuit
or small part. If the problem is more than one of the circuit boards,
the price of repair could go much higher.
I hope I've provided
you useful assistance and that this information allows you to make an
informed decision as to how to proceed from here. Please be sure to
vote on my response. I hope I've earned a good rating from you
Please let me know if I can be of further assistance.
we have the same porblem. We just unplug ours and wait a couple of weeks while watching another tv plug and un plug it will eventually come on then we dont turn it off again it only goes off if the power goes off.