I have a DMR-ES10 Recorder and after a power surge the power supply board is fried. I need a circuit diagram for the power supply please.

If the power supply has already suffered the brunt of the surge, it could be an expensive repair, possibly not economical.

Of course, you can submit this recorder to a service centre, and obtain a quote on any repairs/board replacement required, then make a decision afterwards on that basis - yes or no - it's up to you what you do.

Sorry to say the power surge has quite likely destroyed several components in your DVD recorder's PSU beyond economical repair; it would not just be a 'burnt diode'.

However, in the future, if you are worried about likely surges occurring again, you can always switch units off at the power point when you aren't using them (example, overnight when you go to bed or when you go out for more than an hour at a time). This may help prevent expensive damage to other appliances.

Surge protection on your household power (or a surge protected powerboard/strip if that's cheaper and easier to get) is recommended.

hi,
every electronic equipments comes with fuse in the input side for protection .ur dvds power supply may have some problem. check it before inserting the fuse.
ok

lock

this unit has an optical-eye, not recording heads. opening the drawer then unplugging unit will expose the eye. never look into the eye when unit has power. this x-ray can and will burn your owh eyes lens&retina. good luck. clean with 90% isopropyl alcohol and q-tip. mch

hi....Download instruction manual of DMR-ES10 by clickiing this link http://service.us.panasonic.com/OPERMANPDF/DMRES10.PDF. It is PDF file and can be open / print through adobe reader . for adobe reader, go to www.adobe.com.

thank u
rate me

My Panasonic Recorder DMR-ES10, will not play discs sent to me from the U/K,
using a L.G dr275 recorder, onto a DVD+R disc, how can i overcome this problem. regards Tom Escott.

That's the one who's broken by me. I replaced this cap. and the one right next to it (c1261?), 16V/1500µF

It's working again!!

dsddsdsd

std by light is on?means red light is on.If not than check fuse,vdr,and regulator ic in power unit.if fuse is open than change these component because fuse will blow if the regulator ic is faulty.