How much clorox should I use in my Kenmore HE4T front loader

Pressure may be too high at the source

This site has lots of manuals. http://www.manualslib.com/products/Kenmore-He4t-110-4508-3024385.html#.VPmnI5cyiQE.mailto

If top load, run a washer full long cycle with out clothes and a full cup of Clorox. If a front loader, do the same thing, but then open door after the full cycle is complete. Front loaders are sealed and there is nowhere for the moisture to go..

The Kenmore HE4T washer does not have a reversible door. The matching dryer would have a reversible door.

Some newer washers do have a reversible door but it is still a very small number of washer that allow you to reverse the door.

You can not reverse the door on an HE4T washer.

front loaders are made to sit on concrete they probably didnt tell you when you purchased it if its on wood floor not much you can do

try searspartsdirect.com

Hello wheeljc; I had the same problem when I purchased my Kenmore Elite in 2006. I have a HE4t front load. It's possible that you're using to much detergent, if you're using HE liquid it only requires a small amount and does a very good job.

Before removing try some WD40 spray on the door mechanism, not on door.

Same problem with my front loader. You have to make sure to clean out the rubber trap in the front regularly. it seems to collect alot of hair and plug the drain hole. also it helps to leave the door open when you finish washing to further reduce the stagnant water smell. Use fabric softener for the towels!

hope that helps.