Question about Maytag 24 in. MDB9750AW Dishwasher
The top level in my three level dishwasher are never clean. The dishes do not even look like they are getting rinsed or washed. The dishwasher does not sound like it is working in all of the cycles.
It could be the impeller on the motor. The impeller fits over the shaft of the motor and might have split/broken up. That funny noise is probably the shaft spinning inside the damage impeller. Fortunately the impeler is fairly inexpensive and easy to replace. I believe there are one or two parts/covers to remove that are held in by a roughly half dozen torx screws.
Posted on Jan 10, 2008
SOURCE: Food Deposits left on dishes
I had an old machine with a similiar problem & I found that food had somehow entered into the arm that spins & sprays out water. The food blocked somewhat the holes which of course means less cleaning.
Posted on Mar 05, 2008
Has it always been okay in the past? Do you have the manual, and if so, are you loading it properly. I am not familiar with this particular machine, however there are a few things you can check. Make certain all the spray arms are spinning freely. If there is a "tower" that comes up from the bottom, be certain nothing is blocking the center portion of the bottom rack. Run a load as normal, but stop it after a few minutes. Is there water in the tub and are the dishes wet? If not, determine if the water source is on, and the "fill" solenoid is working. If there is water, and all dishes appear to be getting wet, be certain you are getting a lot of "water action" during the wash. If you listen closely, you should hear a sloshing sound as the machine runs. If not, your not getting enough water circulating. The pump may be clogged, or perhaps there is not enough water coming in. Is your water pressure high enough to fill it completely? I hope I have given you enough things to check in order to lead you to the problem. Let me know.
Posted on Oct 31, 2009
Testimonial: "This is very helpful! Thanks."
Try putting the unit into a test mode. This my clear your issues otherwise call for service.
One of two ways to do this.
In standby (no lights) Press the combination of buttons:
hi temp wash > sanitize > hi temp wash > sanitize > hi temp wash
All lights will come on and the washer will run a test cycle anywhere from 5 to 10 minutes.
If that button comb doesn't work use:
heated dry > sanitize > heated dry > sanitize > heated dry
Posted on May 27, 2011
Tips for a great answer:
Nov 23, 2014 | Dishwashers
Nov 06, 2010 | Dishwashers
May 28, 2010 | Frigidaire 24 in. FDB1050RE Built-in...
Nov 20, 2009 | Magic Chef Dishwashers
Sep 07, 2009 | KitchenAid 24 in. KUDP02CR Built-in...
Aug 04, 2009 | Zanussi 24 in. DA6141 Built-in Dishwasher
Jul 19, 2009 | Kenmore 24 in. 15079 Built-in Dishwasher
Jan 30, 2009 | Roper 24 in. RUD3000 Built-in Dishwasher
Mar 08, 2008 | Dishwashers
Feb 24, 2008 | Frigidaire 24 in. PLD2850 Built-in...
21 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: