Question about Panasonic SC-AK110 CD Shelf System

1 Answer

Sc-ak110 "f61" where i download the schematics of power source of this device??

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 3,130 Answers
Re: sc-ak110 "f61"

Contact the manufacturer in your user manual or here at. 800-211-PANA

Posted on May 02, 2006

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

When I plug it up and power it on ( F-61) come on the screen and it turn it self off. What can I do?

F61 on a panasonic unit usually means a shorted amp ic. Would have to take it in to get repaired.

Dec 28, 2012 | Panasonic SC-AK110 CD Shelf System

1 Answer

F61 cd stereo system SA-AK640

F61 is an Error Code,more specifically a Fault in the Power Amp,the Stereo will need to be sent into Panasonic for Repairs.

Jan 09, 2011 | Panasonic SC-AK640 Shelf System

2 Answers

F61? how do i fix it...................everytime i turn my panasonic sc-ak340 on i get a error code that reads f61 and then my system shuts down by itself..can this be fixed?

I've encountered that kind of problem.
f61 appear on the screen then shuts down the unit.
The very common defect is your fan, output ic (rsn series).
First check the fan if it is in good condition (disassembling the component is quite technical it need a lot of care).
sometimes the fan is full of dirt that's why it will not work properly which the system sense and uttered the unit to switch of avoid further damaged.
If you confirm that the fan is working properly I will suggest you to bring your unit to a qualified technician/service center because replacing the output i.c. is more technical.

Dec 13, 2009 | Panasonic SC-AK340 Shelf System

2 Answers

F61 error

The F61 error indicates that the unit is in "protect" mode. This means that an error condition was detected in the amp section and the unit has shutdown. This is usually caused by a defective amp chip. Expect a parts cost in the range of $60-$90.


Dec 05, 2008 | Panasonic SC-AK17 Shelf System

3 Answers

Panasonic SA-AK600

Try to power on the unit without the speakers connected. If it works normally without the error showing, then a speaker wire maybe shorted or a speaker defective. If the error F61 is still there, then most likely the Regulator IC is defective in the unit.

May 30, 2008 | Panasonic SC-AK600 CD Shelf System

7 Answers

Panasonic SA VK550 - F61 eror

Hi, i had the same problem with a panasonic player, when you see the code F61 in the screen it is because the audio output IC is defective,change that and the set will work perfectly. hope it work.

Feb 05, 2008 | Panasonic SC-AK33 CD Shelf System

2 Answers

F61 error

Isolate problem by disconnecting Amplifier ic (RSN),if f61 still appeares after disconnection of RSN ic ,than check voltage supply rails ,may be one of them has irregularities.

Dec 14, 2007 | Panasonic SC-AK300 CD Shelf System

1 Answer

F61 problem

DIsconnect sound Amplifier ic (RSN).After removal of the ic if the unit works o.k offcourse without sound than replace ic.If still f61 than sound ic is o.k and check voltege regulators in power supply.You can check dc detect line if it gets activated.
F61 is mainly two resons 1st sound ic or power supply problem in power bord which send signal to system control to shut down the power in order not to damege more.

Dec 13, 2007 | Technics SC-EH780 CD Shelf System

1 Answer

My Panasonic SC-A240 shuts down displaying the error f61.

Several components in the power supply maybe faulty, especially Tranisitor Q5110, Resistor R5114 and Diode D5102 on the power supply board. Check and replace these and also resolder the regulator IC's on the heatsink.

Sep 05, 2007 | Panasonic SC-AK240S Shelf System

1 Answer


Hi, I'll quote directly from the service manual Error display - F61 Problem condition - When POWER is switched on, power become off automatically. During normal operation, if DC DET become L, PCNT shall become L and the error display on the left shall be displayed. (IC501) What *I* think that they are trying to say is that the protection circuit will activate if DC appears on the speaker terminals. IC501 the audio output chip may be faulty.

Feb 06, 2006 | Panasonic SC-AK300 CD Shelf System

Not finding what you are looking for?
Panasonic SC-AK110 CD Shelf System Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Audio Shelf Systems Experts

Jonathon summesfield

Level 2 Expert

284 Answers


Level 3 Expert

4518 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Panasonic Audio Shelf System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides