Question about Hoover Nextra HNWL 3136 Front Load Washer / Dryer

1 Answer

Hoover nextra 1200

Unblocked a pipe by filter started machine heard a pop and now no power fuse in plug ok appreciate help how to fix thanks duncan

Posted by on

  • duncam Sep 11, 2008

    this is something i have never done before so would be a little unsure how to proceed

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,614 Answers

HAVE YOU CHECK FOR THE CONTINUITY OF EACH PARTS ON PSUPPLY AREA?

LET ME KNOW

PS CHECK ALSO THE RESISTOR/CAPACITOR

Posted on Sep 11, 2008

  • micromaster
    micromaster Sep 11, 2008

    you a continuity tester to check/test each part, doing this you will identify which of the parts has fail.

    let me know here again.

    regards


×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change pcb on Hoover Nextra HNL 2126 please ?


make sure u photograph were all the wires go back on with ie ure phone

Feb 13, 2015 | Hoover Nextra HNL 3166 Z Front Load Washer

1 Answer

Hoover nextra 8 optima wont drain/empty


check inside the end of the waste pipe, i recently bought a new washing machine and had a similar problem, and checked the waste pipe last. inside the waste pipe was a plug, hope this helps you.

Jun 26, 2012 | Washing Machines

1 Answer

My hoover nextra optima model 7166 cut out now there is no power...It appears the mains cable has some burn marks but the fuse is OK any ideas


Hi from retired Englishman in SW France,

As a guess I would suggest that the mains cable has a break in it, just where the burn marks are, possibly due to flexing back and forth.

REMOVE THE PLUG FROM THE SOCKET.
If it was me I would cut into the cable at the burn marks, strip it back to expose the break, cut back the wires and I would carry out a safe but temporary join- but you are not me!!! You will need to have the cable replaced, sorry ;-0(

If this has assisted and/or clarified the situation for you please consider a 4 thumbs up on our rating.
Thanks and good luck!
John C

Jun 28, 2011 | Hoover Nextra HNL 3166 Z Front Load Washer

1 Answer

No power at machine


no power at machine is the fuse in plug ok. if ok switch off remove plug take off lid and just look at connections from mains cable are they ok and not burned then if ok look at the main pcb make sure connections are tight door switches on these machines were fairly trouble free so i can only advise you on the basics of fault finding with the limited info hope this helps

Jun 07, 2011 | Hoover Nextra HNF 2137 Front Load Washer

1 Answer

My Hoover Nextra 6 has its stop light flashing and the Start button will not kick off any programme?


It could be anything but one of the most likely things is a faulty door switch. What were the circumstances leading up to the fail ? Have you checked the filter? Is there any water in the machine?
Try unplugging it and leave it off for 15 mins.
difficult without any more clues...
I hope I have been of help but please do not hesitate to ask if you have any further questions.
I appreciate your vote if you appreciate my reply.

Feb 27, 2011 | Hoover Nextra HNL 3166 Z Front Load Washer

2 Answers

My washing machine is not finishing a cycle and is not pumping out the water. It will start a cycle, but then it will stop half way through, and the "delay/start" button will flash red. Please help


i had same issue turned out pipe was blocked and washing machine gave up trying to get rid of water, so would stop, cleaned filter, uncloged drainig pipe and was good to go

May 12, 2009 | Hoover Nextra HNF 3157 Front Load Washer

2 Answers

Hoover hnl 6166 not spinning


have you tried cleaning the filter at the bottom. remove the front plateat the bottom and there is a small round plate at the left. this has a screw in it. when you have removed this you give it a twist. a bucketload of water and gunk will come out. i found about 60p in 5's but when it was all removed it started to work again

Jan 07, 2009 | Hoover Nextra HNL 3166 Z Front Load Washer

1 Answer

Issue with Water Pressure


blocked dispenser box Regards Advisor

Aug 22, 2007 | Hoover Nextra HNT 2135 Top Load Washer

1 Answer

Hoover nextra 5+5 washer dryer HNWF 3135 heating broken


it is seperate heaters for wash and dry and unlikely to be connected with blocked filter tho you should check filter regularly. take top off. on manifold running across top you will see stats. one of these at least is resettable by presssing a small knob in middle and if it has gone you will hear a slight click. then check dryer manifole for build up of lint as pooir air flow can cause stat to pop. for wash heating, start by checking continuity of the wash heater located at the bottom of the tub

Nov 04, 2006 | Hoover Nextra HNWF 3135 Front Load...

Not finding what you are looking for?
Hoover Nextra HNWL 3136 Front Load Washer / Dryer Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hoover Washing Machines Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Chris Hall
Chris Hall

Level 3 Expert

842 Answers

Are you a Hoover Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...