Question about Whirlpool ADG332 Built-in Dishwasher

1 Answer

Program The selected dial up program wont light up. Will only run on the rinse/drain program. Seems to be draining O.K.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 30 Answers

Try to see if it flashes an error code, that could help identify the problem. Otherwise, if the problem is only with programming and not with the actual dishwasher, you might want to try replacing the program timer module.

Posted on Apr 04, 2006

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Washing machine wont drain,rinse,spin,water wont drain out start a cycle but seems not to rinse,spin,drain


Could be a failed lid switch. This is a safety switch that shuts the machine off during cycles.

May 19, 2016 | Washing Machines

1 Answer

Bosch dishwasher


,ake sure when it was installed the hose is not higher than the discharge drain, it will create a vacuum and it wont drain for airlock, that's all.

Jan 28, 2014 | Bosch Dishwashers

1 Answer

Programs don't advance. The machine seems stuck in each mode, it will fill and wash but doesn't advance through the programs. I have to switch off and manually advance the dial to rinse, spin, drain etc


Try moving your drain hose to a different height.t may need lower than you have it. My washer did the same , Drain hose needs to be higher than the pump that drains the washer.

Aug 09, 2013 | Indesit W 123 Front Load Washer

1 Answer

AEG Lavamat 74689 Update wont pump out


Possible that the program timer is faulty as it fails to switch on the pump in the required sequence. You can clean the contacts, check the power to the pump, trace the pump power line to the timer which can confirm the case. In such cases the timer must be replaced.

Jan 02, 2013 | Washing Machines

1 Answer

This washing is rubish , it doesnt heat the water, it takes hours to wash if it decideds to wash the clothes!! it wont rinse, wont spin what the hell!!! And when you turn the program dial to cut to the...


It is possible that the machine does not start off the cycle because there are errors or feedback from the inputs. For the program to start up the main program controller must initiate the INLET/MOTOR/DRAIN pump/ valve to open up and allow each function to be driven from the flow into the drum as also the drain valve to open to exit the water at the point of the program cycle. If this does not happen then the voltage at the valve/motor/pump must be checked or the fault relates to no voltage from the controller. This means the controller is a suspect.

Also check the heating coil , check the voltage at the time of heat wash , if not the controller is a suspect. check cost estimation before you proceed.

If the water flows then the flow should be good, if not the inlet valve is bad or there is dirt in the filter. Also check the flow at the inlet of the water line. Once the water comes into the system the WATER LEVEL SENSOR - normally a pressure switch- must activate at the preset/chosen level to give the signal to the program controller to switch on the motor. What is most important for the motor to start functioning is that the door switch must be ON when the door is shut or this will be an error for starting the motor for rinse and wash.

Finally after the wash the drain valve will be activated, the water is allowed to come in to rinse and then finally the dry spin with the drain valve/pump activated so as to drain off all the water from the clothes during the spin.

Make sure that a fault in any of the cycle will relate to the specified action, so check the command from the program module and then the executing device be it the valve or motor or pump.

Please check the link below:

http://www.repairclinic.com/Washing-Machine-Troubleshooting?red=Washing-Machine-Repair-Help

Aug 09, 2011 | Washing Machines

1 Answer

Control dial moves along fine but drain,spin, rinse never happen


replace the water pump. about 46 dollars and a 20 minute job.

Jun 24, 2009 | Maytag Washing Machines

1 Answer

Washing machine will not drain


TAKE THE HOSE OFF ON THE BACK {DISCHARGE HOSE} IF THE WATER FLOWS OUT IT IS THE PUMP MOTOR IF IT DOESN'T THERE IS SOMETHING BLOCKING THE OUTLET, SMALL CLOTHING ITEM

May 29, 2009 | Indesit W 123 Front Load Washer

2 Answers

Machine fills and agitates, but won't drain


Please empty your machine and run the machine empty. If the washer goes through the whole cycle without any clothes. Please let me know

Jan 19, 2009 | Kenmore 24032\24036 Top Load Washer

2 Answers

Bosch classixx 1000 washing machine - stops on spin


Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x

Apr 29, 2008 | Bosch Classixx WVF 240S Front Load Washer...

Not finding what you are looking for?
Whirlpool ADG332 Built-in Dishwasher Logo

Related Topics:

329 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Dishwashers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

Oloyede Monsuru

Level 3 Expert

1417 Answers

Mike

Level 3 Expert

4348 Answers

Are you a Whirlpool Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...