Hi, Aparently the wiring on out Indesit Widl 126 washer dryer is faulty...the machine broke down over a week ago and a man came round the other day and said he had to order new wiring but they are out of stock ...so who knows when we will have the maching mended..has anyone had the same problem? Is there anything we can do? PLease help..please email me at Fififofum8@yahoo.com cheers, Fiona.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
HI, Check back of washe with a flashlight for a bent or clogged drain hose. Do not move washer to check it. When you move it , it will straighten out and you will never know if it was bent Also while it is pumping , pick up end of drain hose at drain and observe the volume of water being pumped. If no water then the Pump needs replaced. Thank you for using fixya Leo Ponder Please rate me if this helped
Asuming the water is in the washer, then it sounds like the element could be faulty, to be certain, you would need to test it with a meter, and don't forget it is filling with cold water, so will take a lot longer to get hot.
this could be down to a poor connection from one pcb to the other, best thing to do is disconnect one block at a time (make a note of where it goes) and clean the connections.
REMEMBER TO UNPLUG FIRST
hope this helps
please dont forget to rate the helpfulness of this reply, thanks kj
Check that the button isn't stuck it if not remove top lid and check the PCB and see if the switch hasn't collapsed causing it to be on all the time. Also if you hold in the go button for about 5 seconds this resets the program try this.
what u can check is the outlet hose does it go down a plastic pipe if so pull it up slightly until it stops a simple mistake if its gone down slightly too much what happens is if its low down the pump kicks in as it thinks the pipe is lower then the washer to drain it try it if i isnt this then it will more then likely be a faulty timer which u will have to replace m8 let me know how it goes m8