F1 error appears just right after I turned the machine.. I had to stop and tstart 3-4 times before it gets on to cycle. Then at 23 minutes F! error error comes back and I had to do the same thing (stop and start) 304 times before it continues back to cycle. this happens evry single time I do my laundry. Thanks.

Cleaning washer filter


Whirlpool Washer Diagnostic Repair F1 Error Code WTW6400SW2

Problem is too much soap. Wrong soap. Press and hold: SPIN SPEED & SOIL LEVEL buttons--then press POWER button.
Wait for door to lock.

Press the START button (6) times--this will fill the tub with hot water to the maximum setting when it stops filling.

Press the START button two more times--this will enable the tub to tumble.
After 3 hours--turn "off" the washer.
Turn the washer back "on".
Select the shortest wash cycle (usually "quick wash") and press "START". This will rinse out the tub.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

depending on its age take a look at the motors brushes. sounds like 23 mins would be spin cycle when the motor picks up speed. they may need replacing.

Instructions Press "Stop" to clear the current cycle on the washer.

1. 2

   Press the "Power" button to turn off the washer. Unplug the washer from the power supply.
   

2. 3

   Wait several minutes. Plug the Oasis washer back into the power supply and press the "Power" button to turn on the washer.
   

3. 4

   Select the desired wash cycle and press "Start."
   

Hi

Thanks for using FixYa. Error F1 indicates primary control failure and to resolve this you'll have to replace the machine control assembly. This error should be fixed by whirlpool as its a common issue with whirlpool Cabrio washers, you can call 1-800-253-1301 whirlpool will send a tech. to fix it and pay for the part. Please rate the solution if the issue is resolved or post a comment for further assistance.

Thanks
Rylee

It is either a bad control or a broken wire.


Oasis manaul

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Mine is doing the same exact thing. Just after I press "Start", the F1 starts beeping. Then at 23 minutes into the cycle, it does it again. So frustrating! What is wrong with this machine?

The Whirlpool Cabrio and Kenmore Oasis (same machine) are infamous for this problem. Depending on the serial number you may be entitled to a new control board installed for free under a recall program. Call Whirlpool for eligibility. I had just had mine replaced last week for free and it runs fine now.

F1 E1, replace Electronic Range Control.

In other words, the controller board has failed.

jenkle, F then 1 flashes when there is a primary control failure. There is a couple of things you can try. 1. Unplug the machine for 2 minutes and see if the error returns. If it does, try activating the auto diagnostic mode. With the washer plugged in and all indicator lights off, select any key except power, start and stop. Here's what you do; press/hold for 3 seconds, release for 3 seconds, press/hold for 3 seconds, release for 3 seconds, press and hold for 3 seconds. If you did it right all indicators will light and 88 will appear in the display. If there are any faults, they will then display, look for a F-60 through 68. This will confirm the board is corrupt. If no faults are found the machine will go through a five minute automatic test cycle. To stop the test, just press stop/cancel. Check your owners manual and see how long the board is warranteed. Catriver