Maytag top loading Quiet Plus/Heavy Duty, 14 cycles washer. Problem: Washer stops working at extra rinse. The time runs through, but when you open the lid, the water is all in there. There is a smell of burn.

hi there.
this is all the info i can find on this.
Key Features

• Catalyst Cleaning Action with Direct Inject

• ENERGY STAR Qualified

• AccuWash Temperature Control

• Variable End-of-Cycle Signal

• 3-Tray Dispenser - Detergent, Bleach and Fabric Softener

• Quiet Wash Plus Sound Reduction System

• Ultra Capacity Plus - Stainless Steel Wash Basket

• 3.8 cu. ft. Capacity

• Multiple Cycles including Whitest Whites, Heavy Duty, Hand Washables and Add-a-Garment

• Multiple Wash/Spin Speed Combinations including High 1000 RPM Speed

• Delay Start

• 3 Temperature Settings

• Automatic Adjustable Water Levels

• Extra Rinse and Rinse/Hold Options

• Side-Swing Door

• SpillGuard Top

• Optional Stack Kit - 8541503
• or see if this link will help you out some more.

What is the capacity of front loading whirlpool washer MO GHW9150PWO...

MLG2000A - Maytag Neptune Super Stack SL-3
1 - Select Wash/Rinse Water Temperature
2 - Select Options (Max Extract, Extra Rinse, Signa)
3 - Select Cycle
4 - Load the Clothes Washer (add detergent on top of the load in the tub, and additives [fabric softener, bleach] in their dispensers).
5 - Start the washer.
This is according to the owner's manual I have. Has worked for 14 years for me.

The washer timing control is defective.

We have the same problem. The Normal cycle still works, but after the final spin cycle, water is again added (1 gal est.) and the machine stops. Problem occurred after washing an old 25 x 30 inch rug which partially disentegrated when washed. We were seeing particles of the rug in subsequent wash cycles during drain into laundry tub. Don't know if something is plugged in the washer or if it is something else. In another load after the rug wash, the top of the washer was lifted during the wash cycle. The water problem occurred immediately after lifting the lid as the wash load went through remaining cycles. Maybe this affected the timer? Maytag customer service suggested unplugging power cord to re-set timer. This didn't make any difference. We need a technician to tell us if this is a timer problem or something else?

lid switch broken

no odds are your whole gear casing needs replaced very expensive

Could be stripped teeth in the timer gears. I take it if you move it a little it starts moving again?
Make sure the lid safety switch is engaged by the pin on the lid.

the timer change by itself. You don't have to change anything.
But cold rinse only works if you have the cold water connect to the washer

where is the lint trap located

Verify Lid switch ..... A solved rating is great motivation to continue giving priceless advise........