I hear the pump but will not spin, I fet a code 11 and F

Check the Motor and Drum: Sometimes, issues with the motor or drum can trigger the F-11 error. Inspect the motor and drum for obstructions or mechanical problems. It's possible that something is impeding their movement.
Verify Water Supply: Ensure that there is no issue with the water supply. If the washer doesn't fill properly during the spin cycle, it can lead to an error code. Check for water inlet valve problems or water pressure issues.
Verify Electrical Connections: Double-check all electrical connections and wiring, not just those accessible from the bottom panel. Issues with the control board or other components may not always be visible from the outside.
Sensor and Switch Inspection: Look for any faulty sensors, switches, or pressure switches that might affect the spin cycle. A malfunctioning sensor or switch can lead to the error code.
Professional Service: If you've thoroughly checked the visible components and the problem persists, it's advisable to contact a professional appliance technician who can perform a comprehensive diagnostic and identify the root cause of the issue. They may need to use specialized diagnostic tools to pinpoint the problem accurately.
The F-11 error code can sometimes be challenging to diagnose because it can result from various underlying issues. If you've exhausted your troubleshooting options and the problem persists, professional service is likely the most effective way to address the issue and get your washer back in working order.

Have you changed the door latch? Is that the clicking you hear?

Hello!

F-11 means a drain pump error.

Pu is short for pump. You say you checked the motor and filter, but is the motor actually running when it should? If it is, you can hear it. If not, there may be a problem where the pump is not receiving power. Armchair troubleshooting isn't the same as actually being there. Keep hunting and you will find the cause.

U codes are User "Error" Codes.

CODE U11
The washing machine cannot drain.
Check that filter is not blocked or obstructed.
Check drain hose is clear of any blockage or obstruction.
Check wiring to drain pump (Done only by a Service Technician.)
Check drain pump is not defective (Done only by a Service Technician.)
Check level sensor or switch (Done only by a Service Technician.)
Check wiring to level sensor (Done only by a Service Technician.)

Many Panasonic washing machines seem to have a problem spinning with heavy loads; they become unbalanced and give a U13 "load out of balance" code. Most other brand machines can spin the same "heavy" load with no problem.

I would be looking at drain pump for obstructions or pump may have failed

hope this helps ya http://fixitnow.com/wp/2009/03/11/maytag-neptune-front-loading-washer-motor-wont-spin-and-lr-error-code/

Pump is most likely clogged .... take front panel off and pump is right there ......

Mike, Sorry to hear that, is there any water around the clutch pulley?  With the front panel removed and you put the washer in a Spin Only cycle with no clothes in the wash basket.  View the Clutch pulley turning CCW and see if is turning true with no wobble? Mine spun off twice before I got it seated properly, and it was in wobble mode until I got it seated properly.   With the water leak issue maybe you can view with the front panel off and a partial fill the leak source. You can always do a quick tub pump out in service mode. As you know unplug the 120VAC to the machine before you poke around in there.  Do you still have the original clutch?  Did you remove the plastic cover and inspect the roller bearings, clutch spring and coupler? Good luck and let’s see what you find. Rich

I would replace both because the falting of HV reg can cause the FET transister to fail also!
I hope this answers your question!
have a good day!