Whirlpool washer awm 6163

Question edited for clarity, add maker, toss in some CAPS.
Question moved to maker category.

Likely needs a new controller board.

https://www.google.com/search?q=whirlpool+awm+1203+stops+at+end+of+cycle

..

Here's a manual in the linky...
Is the drain filter clear?
http://www.whirlpool.ch/uploadsMAM/AWM%205100%20gb%20G.pdf

The Whirlpool UK site has support for the AWM 302. The direct link to the manual is http://docs.whirlpool.eu/_doc/501910006566GB.pdf . If this isn't your model, start at http://www.whirlpool.co.uk/support/instructions-for-use/instructions-for-use.content.html and click on Search. Then search using the Commercial code box. (There are also washers with the commercial code AWM 302/3 and AWM 302/4.)

I hope this helps.

Cindy Wells

Hi,

Problems with a washing machine not spinning or not draining are often inter related..

If you are having a problem with your top load washer then check out this tip...

Washing Machine does not Pump or Spin


If you are having problems with your front load washing machine then checkout this tip...

Front Load Washing machine not draining and or not spinning


heatman101

Hi,
May be the belt at the back of the machine is loosen or cut off kindly check it and replace the belt

If you are talking about the drain pump strainer, you need to remove the lower front panel. should be 3 screws on the bottom facing forward. Once you have that off, the pump strainer is almost in the center, facing you. unscrew it counterclockwise to remove.

you will need a replacement heating element for the appliance

F15 - Motor Control Unit (MCU) Error - Disconnect power and unplug unit to check wire harness connections to the motor, MCU, and Central Control Unit (CCU).
Check the drive belt and reconnect power and plug unit in.
Check the MCU by looking for operations of the drive motor and check the drive motor for powered rotations.
Replace failed component.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

my whirlpool 6th sense will not start all lights and power i think that it is the door sensor at fault? The green light door locked light is not on.

check drain pump for blockage