Toshiba have a toshiba model; 55pj5uc, 55" projector tv. it has bad ghosting in left hand corner which is predominantly red, but the convergance seems to be all lined up. what can the problem be? cheers guys.

Your flux is bad.

Try to do an auto convergence on the TV if that does not work you need to replace the STK IC

ok, it is a ws-55-511? if blue or red will not adjust in some direction you have a bad CONVERGENCE IC--I have start to finish step by step instructions for the repair of this set with this problem.


If you want the instructions provide me a email address and give me a vote here--I am not allowed to post my email address here--It depends on if you can do this repair yourself--this model uses one STK-393-110 CONVERGENCE CHIP--I can tell you where to buy it and how to replace it--


if you have questions or need more help respond to this posting here.

Regards, SD TECH

replace both convergence ics.the ics are stk-110 ics.there are two of them.

its the convergence problem in your power supply board

please check out this links

for convergence board ics reparing it your self

http://home.earthlink.net/~oleg.filippov/ConvergenceFix.htm

and for convergence settings

http://www.somelifeblog.com/2007/06/sony-projection-tv-red-line-repair.html

thanks.

Replace convergence IC'S and check values of convergence circuit resistors.

Convergence is out of line

are you sure it's yoke? these are know for bad convergence amp ic's
other wise it's a screw and glue holding the yoke in place loose the screw and try to break the glue with out breaking the plastic on the yoke, the other thing you can do is adjust the magnets which have tabs on the yoke. i would mark the position's of everything on the tube with a sharpie so you can get it back to start.

Convergence amp ic bad
http://home.earthlink.net/~oleg.filippov/ConvergenceFix.htm
http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html
Sony Convergence
http://www.techlore.com/blog/entry/19694/Sony-Convergence-Repair-My-Sony-TV-has-a-distorted-picture-/
http://www.techlore.com/article/19631/Sony-Convergence-Procedure/

Convergence issue...replace STK392-110 IC's on small PCB
mounted by itself above power supply....................T.

call tech ..suggest c-chips..