Question about Audio & Video Receivers

1 Answer

Request operating instructions for -Pioneer stereo cd deck reciever XR-P150

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Non so far will try other avenues for these operating instructions. Unless you have any ideas.
VICK....

Posted on Sep 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have indash raido and it uts a E1 code and ejects cd how do i fix


Depending on how old your deck is, The lazer eye is probaly hooche ,End willnot read the (Disc) Info, That is what causes aE1 Code,You are better off just to get a different deck,Then have it (Repair) Cost of ( Replacing) the lazer, Can range from $180 to $290. depending on the deck.

Oct 04, 2012 | Panasonic Digital AM/FM Car Stereo...

1 Answer

I have a old pioneer stereo double cassette deck reciever model # RX-Z15, i dont understand the bal/unbal fm antenna hook ups cant get reception , need to know where to hook up the antenna or what kin


Buy a 300ohm FM Y antenna wire screw the spade ends into the balance hookup and fasten the Y section on your wall, "higher the better" this will improve reception. The antenna can be purchased at Radio Shack or Tv repair shop.

Apr 20, 2012 | Pioneer Audio & Video Receivers

4 Answers

How do I hook up my ipod to my pioneer vsx d409 ?


The best way is to use a 3,5mm stereo jack to 2 RCA cable like this:
technical114_34.jpg
You can easily find one like this at your local audio/electronics shop or buy one on line. You have to connect the RCA at any free stereo input at the back of your Pioneer (like aux or cd). Take a look at this picture:
technical114_35.jpg
After this you can use the 3.5mm stereo jack for connecting not only your ipod but every mp3 player or other device has an earphone jack. Just plug the 3.5mm jack at the earphone jack and rise the volume at the portable device up to the middle of the volume range and set your Pioneer input selector at the stereo input that you connect the 2 RCA before (aux or cd)

In case of a problem or clarification or further details needed, don't hesitate to post me a reply before rejecting my answer.
If you are satisfied, rate my solution with the "thumbs" or (even better) add a testimonial.

Thanks and regards
Please kindly rate this solution
Stelios
direct fixya link: http://www.fixya.com/users/technical114

Mar 13, 2011 | Pioneer VSX-D409

1 Answer

Pioneer CD deck Receiver XR P250. Neither of the two tapes work. They dont go round.


Hi John

This is something I can tell you that you can sort out yourself with a little bit of mechanical aptitude and a couple of screwdrivers.

FIRST turn the power off to the unit.

If you pop the lid off the unit, you will see that the capstan drive belts to the tape decks mechanism have failed, Either turned to back muck like windscreen sealant, or just broken and dropped off. The belts (each deck has one) will need to be replaced. The part number for the belt(according to my records) is REB1272 You should still be able to get them from Pioneer spares directly in your country. Let me know where you are and I can get some better information to you.
good luck. Happy to assist you further and answer any questions you may have.

regards
robotek

Nov 06, 2008 | Audio & Video Receivers

1 Answer

I have a Stereo Double Cassette Deck; Pioneer CT-W404R. I've set the REV MODE switch; I've pressed the record button; I press playback and the tape for recording begins moving, but not the other tape. If I...


I was following instructions for "Recording." On the next page were instructions for "Tape Copying," though the first page began with, "Load a tape for recording in Deck II." That sounded like what I wanted. Anyway, that was my error.

Oct 11, 2008 | Pioneer Audio & Video Receivers

1 Answer

SX-1600 + KD-491F


Appreciate the additional information.

To recap what you need is a receiver that can accommodate:
4 - Pioneer S-DF1-K (15-100W, 8 ohms)
1 - Pioneer PD-F407 25 Disc CD Player
1 - Pioneer CT-300 dual tape deck
1 - Kenwood KD-491F turntable

Possible choices are (keeping in mind that the power output should be less if not equal to 100 watts and a turntable/phono input):
i. Onkyo TX-8522 Stereo Receiver;
ii. Yamaha RX-397 100 Watt Natural Sound AM/FM Stereo Receiver;
iii. Sony STR DE695 AV receiver;
iv. Teac AG-790 200 Watt Stereo Receiver;
v. Denon AVR 888 - AV receiver - 7.1 channel.

Some of the above also includes feature(s) to hook up to your video system. Some may even require a fifth speaker (subwoofer).

Incidentally, you can also choose another brand/model even without a turntable/phono input. As initially posted, a turntable/phone to line level pre-amplifier is only required. Here are some examples:
a. XP200 Turntable Preamp - Nano Series;
b. Pyle® Pro PP999 Phono Preamplifier;
c. Pro-Ject Phono Box Turntable Preamplifier;
d. Radial J33 RIAA Turntable Preamp Direct Box

Good luck with your project.

Apr 29, 2008 | Audio & Video Receivers

1 Answer

Kenwood KA-72B Stereo Receiver HELP NEEDED.


Why not plug the cassette directly into the CD recorder? Are they trying to achieve some eqalization change? If not, then this should work. It's all analog at tape level.

Mar 02, 2008 | Audio & Video Receivers

Not finding what you are looking for?
Audio & Video Receivers Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audio & Video Receivers Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

68368 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

Are you an Audio and Video Receiver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...