Question about Sony (CRX140E/CH2) CD-RW Burner

Open Question

Sony CD-R/RW Drive Unit Model NO CRX1611

I need help install it, when i put in my computer I turn the computer back on it try to come up the screen with blank. Help

Posted by on

1 Suggested Answer

SOURCE: I have a Sony CRX320E CD/DVD unable to write a DVD

CD-RW drives can only read all CD-rom and CD-RW formats and read DVD formats but cannot write to a DVD, if you want to write a DVDs you need to buy a DVD-RW burner which can burn all CD-formats

Posted on Jan 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to install cd-rw/crx320ee drive


installing CD drive no need installation driver, just install it like install Harddisk drive but you need to open the slot for your CD drive (dont forget to screw it). after u finish install it just reboot your computer, then the CD will automatically installed.

hope this useful.

Feb 18, 2011 | Sony CRX320EE CD-RW/DVD-ROM Combo Drive

2 Answers

My sony crx320ee cd-rw/dvd stop functioning normaly, cannot burn cd now. plz hlp!


i would recommend uninstalling the drivers completely and reinstalling them, however most drivers for cd roms cd/rw are preinstalled, and the only thing you can update is the firmware for the device itself. you may want to try unhooking the drive and rebooting the computer, then turning off the machine again, and reattach the drive, and restart. that might force it to re-configure and re-load the drivers

Dec 29, 2010 | Sony CRX320EE CD-RW/DVD-ROM Combo Drive

1 Answer

Trying to install a Sony CRX300a DVD


Yes do that is a great idea. DL & copy to a flash drive, then run software from drive.

Feb 06, 2010 | Sony CRX300A (CRX300E1BLACK) CD-RW/DVD-ROM...

1 Answer

Computer turns off due to new installed hardware (cd-rom drive)


Then only one more check to do before we can fault the new unit , the new unit should have jumpers at the back of it. If it is the second unit of that type installed ensure the jumper settings is set to slave and not master which is default. If it is the only unit (cd rom/dvd rw) then you have a faulty new unit. Best way to is to insert in another friends machine to double check before taking it back.

May 12, 2009 | Samsung TS-H542A DVD±RW Burner

2 Answers

Why my [sony cd rw dvd rom] will not detect a blank dvd disk


If you have the sony CD RW DVD ROM then you can't burn the data in a blank DVD.

Because your Configuration is :
Read : CD / DVD
Write : CD

This means you have a combo drive. But to burn a DVD you should have DVD RW.




Mar 09, 2009 | Sony CRX320EE CD-RW/DVD-ROM Combo Drive

1 Answer

Sony DVD RW DRU-820A


Hi,
did you try to do the emergency eject ?
jewellers driver in drive pinhole.
use the eject method again, Computer powered Off. Open the drawer and push it back in firmly.
This is an eject button, make/break switch problem.
Also try ejecting the drive from my computer/Right click with mouse ( CD Drive ) Eject.
And ensure the 4 Pin Molex ( Red-Black-Black-Yellow ) is the right way round. Yellow usually faces to the outside of the casing.

Mike @ compurepair.

Jul 01, 2008 | Sony DRU-820A DVD RW Dual Layer Burner

1 Answer

Sony DVD RW DRU-820A


HI,
Double check the Ribbon Cable Connector is installed Correctly ( 40-80 Strand IDE ) sometimes if these are not fitted squarely Or pushed in hard enough. Can cause a Problem.
Also try the emergency eject procedure on The Drive. Small jewellers screwdriver Or Needle, insert into the drives faceplate ( pinhole in drives faceplate drawer ) push to open dvd drawer. pull out drawer Gently. And push back in. This ocassionally works for a stcking Drawer/eject mechanism.
Finally try the drive without a disk in ( open/eject Or Close )

Mike @ Compurepair.

Jul 01, 2008 | Sony DRU-820A DVD RW Dual Layer Burner

1 Answer

Sony CRX300E CD-RW/DVD-ROM Combo - DVD doesn't read


Hi,
do you have software/program that supports DVD.
Try a different DVD/Movie/Disk or alternative.
Also install a program, such as Nero which will give you physical characteristics of the drive.
Finally go to device manager, and remove or uninstall the device, reboot the computer and setup again. This can sometimes remedy the problem.
ensure that the drive is set as Master/Slave. if on the same Bus/IDE channel as a hard-drive. set as master/slave opposite to what the hard-drive is setup as.
Hope this helps.
Mike @ Compurepair.

Feb 24, 2008 | Sony (crx300e) CD-RW/DVD-ROM (Combo)...

1 Answer

Install to computer problem


Hi,

Sounds like a case of jumper settings. If the CD-RW was installed as secondary IDE to an existing hard drive which is the Master, pls set jumper to SL. They are located at the rear of the CD unit between the IDE connector and the audio out.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Feb 19, 2008 | LG CED 8120B CD-RW Burner

1 Answer

FAILURE OF CD READ/WRITE UNIT SONYCD-RWCRX140E


THERE IS A HARDWARE PROBLEM IN THIS, GET IT REPAIRED FROM SONY AUTHORIZED PERSON WITH SONY ORIGINAL PARTS. THINK THERE MUST ME PROBLEM IN LENS OF YOU DRIVE.

Nov 19, 2007 | Sony (CRX230E1/10S) CD-RW/DVD-ROM Combo...

Not finding what you are looking for?
Sony (CRX140E/CH2) CD-RW Burner Logo

Related Topics:

310 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony CD & DVD Burners Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Shahzad  Waseem...
Shahzad Waseem...

Level 3 Expert

746 Answers

Cindy Wells

Level 3 Expert

4758 Answers

Are you a Sony CD and DVD Burner Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...