My printer has been a big pain forever.It's only four years old. I use ink from an "inkstore" on-line, which I have been using forever, so I doubt that's it. But I just bought 2 boxes of ink and had I not done so, I would throw my printer as far out the window as I can! Any help for me? Thanks so much
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
EPSON T13 WITHOUT CHIP , INK LEVEL ALWAYS FULL,
NO NEED TO RESET INK LEVEL EACH TIME .
INK LEVEL AUTO RESET WHEN PRINTER SHUT OFF.
INK LEVEL LEVEL ALWAYS SHOW 100 %
NO WASTE INK PAD COUNTER MORE
NO NEED TO WORRY WHILE PRINTING MORE PRINT JOBS
Inkjet printers all operate the same basic way. There are differences but the basics are the same for any inkjet devices. Eventually a buildup occurs enough that your printer doesn't print. Cleaning cycles use more and since inkjet ink is worth about $8000 a gallon, this is a expensive way to clean something.
So what can we do to clean this just a bit cheaper? We need to find a suitable solvent that will dissolve these deposits without harming the print head. And the one that works great and is dirt cheap is good old household white vinegar. Next we want to get some lint free (preferred but not critical) paper towels. And a clean clear table top to work. You may want to put down some newspaper. This isn't that messy to do but it can get the odd bit of dissolved ink on things.
Now we take the printer and remove the paper and the ink cartridges and set aside. The print head is a small stamp sized thing on the bottom of the cartridge holder. Take about 1/3 of a sheet of paper towel and wet it with vinegar. Next you want to get the wetted towel under the print head. It should fit as this is where the paper goes you print. The towel is a thicker but it is soft. move the print head back and forth over the towel. When the towel is covered with ink, change it and repeat. Keep repeating this until the towel comes clean. It will only take a few minutes. When the towel is clean then you are done. Replace the ink cartridges and paper and you are ready to print.
Epson t13 all problem solved
EPSON T13 WITHOUT CHIP , INK LEVEL ALWAYS FULL, NO NEED TO RESET INK LEVEL EACH TIME . INK LEVEL AUTO RESET WHEN PRINTER SHUT OFF. INK LEVEL LEVEL ALWAYS SHOW 100 % NO WASTE INK PAD COUNTER MORE NO NEED TO WORRY WHILE PRINTING MORE PRINT JOBS
You can't turn it off on this model. If you don't want to use paper, that is fine, but just make sure you take out the ink roller so it doesn't build up ink in the printer. then you can run it without paper and it won't be damaged.
You might want to check the memory on your printer, since it your printer has a low memory then it could take forever to print. I would check the setting for the printer and see if the box labeled start printing after last page is spooled, becuase then the printer will wait for the entire document, you want to change that to start printing immediately and make sure spool print documents is cheecked.
Hi. This is very common. It usually means you have not been replacing the ink roller on time and now it is coming to pieces and getting stuck all over the drum in the printer. Replace the ink roller (never re-ink it) and then clean the little number wheels on the rotary drum in the printer. That should sort it.
You may want o try this cannon.Less than a hundred bucks..Canon Selphy CP760
Reviewed on 05/28/2008The bottom line:
The Canon Selphy CP760 takes the pain out of printing photos with its
plug-and-play design and straightforward usability, and the $100 price
tag makes it an excellent companion printer for quick prints in the
home. Read review Specs: Compact photo printer - Dye sublimation - Color, 4 in x 8 in, Wired, PC, Mac, USB, Direct print USB RICHARDM69
If the printer prints didnt print anything at all and you know that you are having ink in it and there is no fault somewhere then go to your printer setup and put your printer to default printer then it start working ok
rate this solution