Question about Panasonic TX-32LX1F 32 in. LCD TV

1 Answer

Problem with panasonic tv

Picture keeps going off replaced by vertical coloured lines. switching tv on and off rectifies it but happens every 10 minutes or so. not sure of model but has a blue light behind controls on tv when in standby mode

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Mentor:

    An expert who has written 3 tips or uploaded 2 video tips.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 116 Answers

It is usually caused by problems from lead solder that sometimes does not connect, so there are some points of the components that are not connected with lead solder to the circuit. if it appears vertical line means from the IC (integrated circuit ) Vertical, you can solder all the points in the IC ( Integrated circuit ).

Posted on Jul 23, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why I have a thin line across the screen in my TV model Panasonic TC 21. After replacing the vertical IC the horizontal line across the screen reduced to few inches and not as it was earlier. vertica


First, You should to replace by original part, then you should check the voltages on power supply, and check the voltage for vertical IC based on datasheet, also check the voltages on vertical section including yoke and last you should check the ESR capacitors on vertical section.

Oct 13, 2014 | Panasonic TC-21PM10RQ 21" TV

1 Answer

Panasonic LCD TV Modeel No: TX-26LXD8A has vertical coloured lines that change colour depending on the program/picture. It began with a vertical red line near the centre of the screen and now there is no...


Other than taking the television to a repair shop not much can be done. I recommend a new television. Excellent brands are Sony, and Samsung. Both brands are quality televisions. Best of all you can order them on Amazon.com for lower prices.

Jan 23, 2014 | Televison & Video

1 Answer

Vertical line on tv screen


This problem have been answered.

Aug 22, 2012 | RCA TruFlat 27F520T 27" TV

1 Answer

Panasonic plasma tv th42px8ob 2 inche vertical line showing


do the proper isolation proceedure and try unhooking the Su from the SC board to see if you then get a normal picture all the way across the bottom half of the screen? I am assuming the Vertcal extends extends all the way from top to the bottom of the screen?

Aug 06, 2012 | Panasonic Televison & Video

1 Answer

There is a horizontal line in the mid


Hello

The vertical scan of your TV has failed. All picture tube type TVs have both horizontal and vertical scan sections to scan the picture on the secreen. When horizontal scan fails, you will see a vertical line at the middle of the screen, and if vertical scan fails, there will be a horizontal line through the middle of the screen. In your TV, the second stated has happened.
This may be due to an IC trouble or a voltage loss inside the printed circuit board of your TV. To rectify this fault you have to open your TV, and locate the vertical output section inside it. It is very easy to locate that section. There will be four wires goes from the deflection yoke; the coil fitted at the neck of the picture tube; out ot which, two will be thick and the other two will be thin. The thick wires are usually colour coded as red and blue. Colour coding may differ from set to set. Anyway you have to follow the tow thin wires, as they are carrying vertical scan signal to the yoke.
Following it, you will reach to a plug in point on the printed circuit board. Upside down the printed circuit board, and follow the track through which that wire connection goes, and finally you will reach to the vertical output section.
There may be transistors or IC used on that section. First check the voltage at the vertical output section. Voltage lose also may occur in this section. If it uses IC, check for any loose or bad solderings at the terminals of the IC. I advice you to resoder the suspected points by applying a little more solder, without shorting the terminals. In most cases this will solve the problem. If there is voltage, and there is no loose solderings and still the fault perists, replace the IC or transistors, whatever it may be, with same type and number.
If you want anymore asistance, fee free to contact me through Fixya. OK.

Dec 27, 2010 | Toshiba CF30F40 30" TV

1 Answer

Sony Trinitron Colour TV Stopped showing and switch light flicker


The vertical output IC has failed/Power to the vertical IC is out/ or there is bad solder on the pins of the vertical output IC.

Dec 01, 2008 | Sony FD Trinitron WEGA KV-34HS420 34" TV

1 Answer

Th-50px70b


when doe s this happen on hd tv bad signal on antenna will cus ethat to happen heavey comprsed dvd bunred will also do it may need better antenna ok

Oct 06, 2008 | Panasonic TH-50PX60U 50 in. Plasma HDTV

1 Answer

Lines on tv


Set starts, horizontal and vertical deflection work, HT ok, crt heaters ok, but no sound or picture
I turned the G2 voltage up and noticed a white screen with flyback lines, frame ok. I detected two badly soldered double diode rectifiers in the secondary part of the power supply ! I checked all other joints, and everything was ok !! success
White horizontal line (no vertical deflection)
Check / replace R548, R549
Sound but no picture except for a couple of horizontal colour lines
Replaced the frame chip TDA8356, set now ok

Nov 23, 2007 | Mitsubishi WS-65511 65" Rear Projection...

1 Answer

No picture


a bright thin line in centre is called horizontal line. first of all do not keep tv on unless it is rectified. BUT If you want to put on tv keep brightness minimum to protect your screen for any demage. now solution your problem is in vertical section. 1 check vertical supply. 2 check parts in vertical section or loose contact. 3 yoke connrctor loose 4 ic defective It is not serious problem can be rectified easily

Sep 19, 2007 | Toshiba 32DF46 32" TV

1 Answer

Panasonic CT-32hX41 vertical picture problem (hourglass)


this product has a pincushion problem and requires servicing but unfortunatley it is what we call in the business NECO

Dec 05, 2006 | Panasonic CT-27HL14 27" TV

Not finding what you are looking for?
Panasonic TX-32LX1F 32 in. LCD TV Logo

221 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Televison & Video Experts

 Grubhead
Grubhead

Level 3 Expert

4706 Answers

The Knight
The Knight

Level 3 Expert

70983 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Panasonic Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...