Question about Frigidaire GLTR1670A Front Load Washer

2 Answers

WASHER WON'T START

The live chat disrupted before I could read your idea, and this is the first chance I've had to get back with you. Can you tell me again what to try? Unplugging the washer (over night) didn't fix it.

Posted by on

  • judyarbo6299 Sep 29, 2008

    the washer fills and drains, but won't agitate...what's wrong and how do I fix it...Thanks for your help

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 943 Answers

HI .THANKS FOR THE QUESTION. IS THE DRAIN HOSE LOWER THAN 36. INCHES FROM THE FLOOR ,THAT COULD BE YOUR PROBLEM .IF LOWER RAISE THE DRAIN HOSE. THANKS THE APPLIANCE DOC

Posted on Oct 04, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi again,

Appreciate getting back to me and the direct "Ask Me".

My last response in the Live Session was:

  • let's try Plan A first. pls have the unit plug back into the mains, wait for about 10~15 seconds to stabilize electronics, press and hold "options" and "select" buttons continuously for 5~10 sec or until a single beep is heard.
Pls try the above procedures and update soon as convenient.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Posted on Sep 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I replaced the door seal on a Whirlpool duet ht washer and now it won't power up. I've checked all the connections and they appear to be tight. Any ideas?


I have one idea. Could the new door seal be preventing the latch interlock from functioning to allow the machine to start?

Apr 17, 2013 | Whirlpool Washing Machines

1 Answer

Cabrio washer won't fill normally but diagnostic shows valves are fine


when doing the diagnostic testing machine fill up almost full and stop display an ol mode

Apr 17, 2013 | Whirlpool WTW6400SW Cabrio Washer

1 Answer

Washer won't start


Sounds like the door lock may be faulty or it isn't closed fully. If it has a child lock check you haven't set it by mistake, you have to hold the start for 5 secs+ to override it.

Mar 07, 2013 | Bosch Axxis WFL 2060 Front Load Washer

1 Answer

I have a kenmore elite HE3 washer. I was getting the sud error and then eventually F02. I cleaned out all the drain lines and pump filter trap and this did not help. I've now replaced the pump


I endevor to purchase a new unit. I've had the same electrical issue with the "F" variable coming up for EACH cycle. I've pressed the Pause/Cancel button and attempted to resume the cycle. While that did work, again, the "F" would come up and the cycle disrupted. I think I will end up paying quite a bit to have it serviced. My washer is 7 years old and I've had it serviced twice to date. I intend on purchasing new in the New Year, a Samsung or LG.

Nov 24, 2012 | Kenmore Elite HE5t Washer

1 Answer

Dl and F flash when I'm trying to start the cycle...


sorry for the delay in getting back to you. you have a bad door latch mechanism on your washer that needs to be replaced.

Dec 28, 2011 | Whirlpool Duet GHW9150P Front Load Washer

1 Answer

Washer (total care system) is making a humming noise even though I've taken all the clothes out of it. The agitator works, but there's a humming noise. I've stopped it and re-started it, but...


Hi

1 of 2 things could be the trouble.

Does the washer drain properly if you manually turn the control knob? If not then this sounds like your pump is either plugged with possible lint and can't move or has died completely. 99% chance pump is the problem and 99% chance it can be an easy fix by cleaning the pump where the Drain Line is attached, worst case scenario pump is to be replaced, but not a overall expensive fix and most can do it without a technician.

Second problem is possibly the time itself, but if the washer is going through all cycles except spin then pump is likely the culprit, cause in spin cycle the machine has to drain the water from the unit as it spins, if it cannot the washing machine basically stops and cannot complete the cycle.

One way to tell for sure if the pump is the problem. When the machine enters the spin cycle and starts making that noise. Manually turn the dial a little bit till it passes the spin cycle, if it continues to wash till it hits the final spin/drain cycle then stops again...your pump is in need of help.

Please get back to us if you have further query or else please accept the solution.

Thanks for contacting fixya.com

Sep 04, 2011 | Kenmore 24032\24036 Top Load Washer

1 Answer

F1 error code on Kenmore Oasis He


Moister can get in between the contacts,is it in a high moister environment? Try using a hair dryer on the panel to dry it out.Also unplug it to reset.
Hope this helped.Let me know by rating me
For more help go to live chat.
lenwest

Jan 31, 2009 | Kenmore Elite Oasis 27052 Top Load Washer

3 Answers

WASHER WON'T START


You made the right call!
But!
If that does not work then you needs a hands on tech! Sorry
Please give me a rating before you sign off

Sep 05, 2008 | Frigidaire GLTR1670A Front Load Washer

2 Answers

WASHER WON'T START


possible door latch or even the strike on door itself may be broke

Sep 04, 2008 | Frigidaire ATF6000ES Front Load Washer

2 Answers

Maytag top load neptune washer


Have no idea why you would only get 20V at the pump when you get the full 120V in test mode. However, if you do get 120V, not 20V, then the chances are that the water level pressure switch is giving a faulty reading which tells the board that the basket is already empty.

Apr 29, 2008 | Maytag Neptune FAV6800AW Top Load Washer

Not finding what you are looking for?
Frigidaire GLTR1670A Front Load Washer Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Washing Machines Experts

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Are you a Frigidaire Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...