Effect off Hi, I am having problems with the remote for my dsp a1000 and I cannot seem to be able to remove the "effect off" display from my tv screen. Any help would be greatly appreciated. ZForce

Contact Yamaha directly. Service Centers are probably limited. Don't take it to just anyone. I can fix it, but I'm in California, USA.

I would recommend you get a new remote.

If you run through the setup and certify it knows about the center channel first, then test it with tiones, then maybe swap the center speaker with another one you might come to an answer.

Are you certain they are at fault? It could be that the Yamaha isn't responding, due to a faulty remote censor. Try a good universal first to be certain, before attempting repair of the remotes.

Go to Yamaha's web site and download the user manual. It's free!

Be sure you are using the AUDIO OUT on the vcr then going into a AUDIO INPUT on the DSP A1000, this will allow the DSP A1000 to amplify the audio line level.

My amplifier turns off after 5 seconds, what should I do to fix this problem

volume levels on all channels varies depending on what dsp mode you are using. to be able to determine the level you desire, just chnge the level setting of those channels. either you do it by remote control or the front panel of the amp. try setting the dsp mode on disco and you should hear higher vol levels on all channels. Do not expect as well all channels to produce same vol levels as your effects speakers may not be able handle higher power levels.

i have problem with amp yamaha dsp-a1000 the led the volume it like blinks everytime is good the transistor the output is good, i dont no whats happening can u help me please

output stage problem, systems trips due to protection. have the power amp transistors checked. the rotating of function switch is normal, its like a routine system check