Question about Uniden Cordless Phone
Dude you've got a very good solution rating on this site...i was wondering if you can help me..
I've got a uniden wdect 2355 cordelss phone with 3 handsets and all 3 display registration failed when i try to register them with the main base....can't do anything beyond that ..not even use the menu..
sorry about being a bugga mate
thanks in advance
SOURCE: re. call waiting
Using Call Waiting
If you have Call Waiting service and a second call comes in when you are on the phone, a call waiting tone will
sound. Press [ /Flash] to accept the waiting call. There is a short pause, and then you will hear the new caller. To
return to the original caller, press [ /Flash].
Note: You must subscribe to Call Waiting service for this feature to operate. Not all features are available in all areas.
Posted on Mar 23, 2008
Same manual as lethean provided on a similar post but Page 24 if the previously used Base is Unavailable and your phone shows "Deregistration" in the Menu.
Base Unavailable (Handset Only)
To clear the base registration data in the handset, please follow these steps:
Press and hold  and [#] for more than 5 seconds. Select the BASE UNAVAILABLE submenu.
BASE UNAVAILABLE appears. Move the cursor to select YES, and then press the OK soft key.
ARE YOU SURE? appears. Move the cursor to select YES. Press the OK soft key.
Posted on Nov 01, 2008
One has to completely deregister all handset by pressing end and # keys together till complete de registration is shown on handset screen. if the de registration is not done as above stated method the hand set will not register will show connecting on hand set screen.
Posted on Nov 07, 2008
I had a similar problem which I finally fixed. You did not say if any of your phones registered.
First try the following recommended by Uniden Support:
Your phone(s) should be fully charged before putting them on the main base.
Unplug the battery from the phone by removing the battery cover and removing the connector. Then, push the # and * key together and hold while you plug the battery back in (requires some dexterity). Continue to hold the two keys until you hear a confirmation tone. This will force the phone to reregister. Put the phone on the main base (if you are sure it has a fully charged battery) and see if it will reregister it to solve the problem.
That did not work for me. So, I followed the instructions to de-register the handset (even though it hadn't really registered). But, I also pretended like the Base was not available (because using the base in this step also failed).
1) Press and hold the hang up and # keys for at least 5 seconds.
2) Move the cursor to select Base Unavailable and then press Select.
3) Select the base you want to deregister from, press Select and then move the cursor to Yes and select.
This causes the phone to delete any of its base information.
At this point, again insure that your phone shows the battery is fully charged and if it is not, put it on the stand alone charger base (not the main base). With the battery fully charged, place it on the base and try registering again by placing it in the main base.
If neither of these approaches help, contact support at Uniden.com.
However, my problems were cleared when I cleared the handset with the second set of instructions.
Posted on Apr 26, 2009
Tips for a great answer:
Apr 19, 2010 | Uniden DECT 6.0 Cordless Phone ID
Dec 13, 2009 | Uniden Cordless Phone
Dec 06, 2009 | Uniden Cordless Phone
Jan 09, 2009 | Uniden Cordless Phone
Oct 27, 2008 | Uniden 2.4 GHz Cordless Phone System
Aug 16, 2008 | Uniden Cordless Phone
Mar 19, 2008 | Uniden Cordless Phone
Oct 14, 2016 | Uniden Cordless Phone
49 people viewed this question
Usually answered in minutes!