Computer failure 4th september-Thursday-2008. Have gone to use my acer today pressed the switch and guess what nothing happened. I have illuminations for networking but nothing else. Power button refuses to respond have dug out ancient computer to contact you for assistance.

usually, this message means that when your computer is booting it is trying get the operating system files from a network location (shared folder)

what you need to do is to make sure your BIOS is not set to boot from network.

1. when the computer starts, there is a message like "to enter BIOS press Esc" or any other key like F2 or F10
2. in the BIOs settings, make sure the order of the boot is: DVD/CD then hard disk. make sure there is no Network booting in the list

Check your power cables properly and make sure it is attached. Check your power button, maybe you have pressed the wrong one.

Same thing happened to me! Went to bed last night, everything was fine. Woke up today, orange light came on, no display, slight flickering seen, but that's it. Cables and cords are fine, tried unplugging and plugging it back in, NOTHING. Totally dead. I'm guess off to buy a new one today. Typical made-in-China JUNK.

could be a cable has come loose or the reginal settings have been changed

iPod Nano 1st Generation - March 26, 2006

http://manuals.info.apple.com/en_US/iPod_nano_Features_Guide.pdf

iPod Nano 2nd Generation - September 11, 2006

http://manuals.info.apple.com/en_US/iPod_nano_2nd_Gen_Features_Guide.pdf

iPod Nano 3th Generation - January 1, 2008

http://manuals.info.apple.com/en_US/iPod_nano_3rd_gen_Features_Guide.pdf

iPod Nano 4th Generation - September 9, 2008

http://manuals.info.apple.com/en_US/iPod_nano_4th_gen_UserGuide.pdf

bring it back for repair

There isn't anything wrong with your car. This is perfectly normal. I have a 2000 ES300 as well as other people that I know and it operates in the same way. Overdrive doesn't mean the same thing for every car or transmission. In our case overdrive is simply a reference to the top gear which is 4th gear. When you switch overdrive off(which is depressing the button causing the O/D OFF dash light to illuminate,) the highest gear becomes 3rd because you turned 4th gear or overdrive off. The application scenario for this is usually mountainous terrain where a lot of uphill driving makes it more feasible not to up shift into 4th gear while ascending and descending. It will not switch back to overdrive or 4th gear until you re-engage it by turning the overdrive back on or repressing the button. Again, when the O/D OFF dash light is illuminated, overdrive which is 4th gear is off and the highest gear will then become 3rd. It will never shift into 4th gear while this light is illuminated or overdrive is off. When you press the button and the O/D OFF dash light is NOT illuminated overdrive is on and therefore it will shift into 4th gear as usual. This applies to all 97-2001 ES300's and probably any other car you drive tat exhibits this same type of change when overdrive is turned off.

Just set it to record"today" choose the correct day and month,the year will be unimportant.

YOU HAVE TO LOOK INSIDE , check the PC BOARD , look for some kind of burn in the solder points around where a small transformer is , re solder anything that looks suspicious , try again , hope this helps AJ

I guess I can assume that you have it plugged into the ac power, so you know its not a power problem. We also know its not a problem with the power switch since the light turns on. So that leaves, motherboard, cpu, and ram possible problems. Ram would unlikely cause such a hault. Even with no ram, I believe the computer would make horrible beeping noises. So if its a problem with the motherboard or cpu, its pretty much trash, unless you want to waste the money on ebay or some place for another cpu to try to swap.