I bought the fast lane R/C FA-005 Helicopter and right out of the box, the controller wont connect to the copter. It says in the book to give it full throttle then back down to none, , It has connected once since i've had it and ran for about 2 minutes, and that was all,, am i not doint something right here? The light on the controller just keeps flashing that it dosn't have a connection with it,, what should i do,, I know it works cus it did b4.. the store don't have anymore, and i'd really like to get this one working..
Re: I bought the fast lane R/C FA-005 Helicopter and...
If the controler light is flashing try new batteries.the light should stay on. Also try and make sure your not around any thing that would give off electrical interferance
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Make and model would help a lot here, but many of the controllers on the small remote control helicopters need to be reset after a crash disconnects the link. You do this by turning both the helicopter and the controller off, then turn the 'copter on first and the controller second. When the lights on the 'copter indicate a connection, take the power control lever on the controller and push it first all the way up, and then all the way down. This resets the controller and should enable the link again.
Good luck!
Is the "flight light" blinking on the copter? If you connect the USB cable to the copter will it power up? Have you tried different batteries in the remote? Check the pins in the charging port on the copter, Otherwise there's not a lot that can be done with these little RCs.
It would not sync. solution was to assume poor technical writing.
step zero. turn the controller off.
step one. plug in the battery to the copter.
step two. QUICKLY turn the controller on. if you miss this small window of time, it is going to fail. The copter light blinks fast during this period, and if it slows the blink rate, then you have waited too long.
Hi,
You bought a defective mini copter, the internal micro relay is malfunctioning and I hope you could bring it back where you bought it. Replace it with a new one and let them try to test flight it before you go home.
Hi, My X107 MINI HELICOPTER does not receive transmit anymore. It was working fine before. It only flys if I hold the remote control right next to the sensor. If I move it away it loses transmit. Both units have full power. How do I solve this problem.
did you turn the radio on first. It must be powered up with the throttle stick at minimum. Turn power on and then move stick to maximum and back to minimum. The remote lite should stop flashing and then power on helicopter.
sounds like remote control is out of adjustment. Instruction book if you have one shows how to null out the rotation i found that if not right to much rotation the main blades lose some power. When i adjusted it to cancel the rotation the copter lifted quickly. may be the problem. adjustment is on the lower rigfht of controler.
Mine's exactly the same as yours. Although the transmitter shows A B C the switch has only two positions, so there's a choice of two only. I doubt it's possible to fly 3 at the same time.
×