Question about Frigidaire Affinity ATF7000E Front Load Washer

1 Answer

Frigidaire affinity front loading washer

My washer pours water out of the front of the machine through the soap dispenser door. The dispenser is shut, so why is this happening. It also leaks slightly through the bottom of the door. We have had numerous problems with this machine right from the get go. We had to have the pump replaced as it would not spin out clothes, and it shakes really bad, even though the machine is level. My biggest problem right now is the water though. Any suggestions?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Pull the top off by removing the screws on the back of the top of the washer then the top will push back and left off. From the front reach down on the left side , there is a hose that gos from the bottom of the soap dispenser the gos into the front of the drum, you should be able to pull it out of where it gos into the drum chances are there issomthing stuck in it or there in the drum where the hose gos in. Note you may have to take the screws out of the soap dispenser and push it back a little to get your arm down in there to get ahold of the hose.

Hope this helps....
Brian's Appliance Repair

Posted on Sep 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Frigidaire affinity soap dispenser doesnt work


Good Morning Friend, this is Z. I appreciate your post!

I see that you have a Frigidaire washer and that you are having trouble with the soap dispenser. Is the soap dispenser not dispensing bleach or softener? Is there water left in the dispenser? Are you able to open and/or close the dispenser? Also, may I have your model number please? You can normally locate the serial on the upper front, as you open the door. With this information I can better address the issue at hand. Thank you!

Jul 26, 2014 | Frigidaire Washing Machines

1 Answer

Frigidaire Affinity washer not dispensing soap


Does water come into the soap slot; if it doesn't the small hose connecting to it has disconnected. To access this you must open up the top of the machine to locate, connect. Another aspect could be the soap slot could be blocked with old soap, and water could be overflowing into adjoining slots. Try to gently remove the push tray to clean out.


Click if helped pl.

Apr 05, 2013 | Frigidaire ATF6000ES Front Load Washer

1 Answer

Water is pouring out of where the soap dispenser is. Can anyone help?


its pouring out because the dispenser is getting clogged in somewhere and not letting the water to the drain pump so its pouring from the soap dispenser. Remove the dispenser, pour water into the opening and make sure water can get into the machine freely. Inspect the opening for soap build up.
If water goes down slowly , open the washer door and feel around the bellow for anything blocking the water inlet port into the washer (socks can sometimes get wedged up there and cause a blockage).
If it all checks out ok, make sure the machine is properly leveled and not leaning forward.
Hope that helps!

Jul 09, 2009 | Kenmore 43142 Front Load Washer

2 Answers

Mildrew, stale water smell in laundry


Run a very hot wash on your machine with no load

Fill a bucket with a strong solution of soda crystals and pour it into the machine first

Add some more crystals to the soap dispenser

Use an old fashioned soap powder for a couple of washes as well and reduce the load slightly

Modern soap powders do not contain certain bleaches and soda and the 40 degree wash leaves body fats and oils inside which cause odours

Jul 03, 2009 | Frigidaire ATF6000ES Front Load Washer

1 Answer

The washer door wont shut or lock on my frigidaire affinity


in the rubber seal around door to washer tub ensure there is nothing inbetween rubber.

Apr 21, 2009 | Frigidaire Affinity ATF7000E Front Load...

3 Answers

We have a Maytag front load washer Model MAH 4000 AWW


tHE PROBLEM IS YOU NEED TO CLEAN YOUR SOAP, SOFTENER AND BLEACH DISPENSER, REMOVE THE BLEACH AND SOFTENER DISPENSER TRAY, AND YOU WILL FIND THAT IF YOU HAVE BEEN USING LIQUID SOFTENER, THAT IT HAS GUMMED UP AND CLOG THAT AREA AND IS CAUSING SPILL OVER. WHEN THE WATER IS POURED INTO THE TRAYS TO DISPENSE THE BLEACH AND OR SOFTENER.

Mar 18, 2009 | Maytag Neptune MAH7500A Front Load Washer

1 Answer

E10 error code


1 beep and E10 is listed as the dispenser door is open. Try reclosing your soap dispenser door tight.

Jan 18, 2009 | Frigidaire GLTF2940E Gallery 3.5 Cu. Ft....

1 Answer

I have a Fridgidaire Front Loader Washer _ Affinity. It has an error message flashing. E10. What does that mean? What do I do to fix it?


I have a Fridgidaire Front Loader Washer _ Affinity that flashed the E10 error code. I also had the problem with the fabric softener dispenser not emptying, and staying full of water. The problem was the cold water filter on the back of the washing machine that was semi-plugged. Cleaned the filter and now works perfectly. My machine is no longer flashing the Error code 10. The dispenser works perfectly.

Oct 05, 2008 | Frigidaire Affinity ATF7000ES Front Load...

3 Answers

WATER LEAKING FROM FRONT BOTTOM


try onscrewing top panel on machine...when machine agitaes strongly a hose my pop lose up from top.

Jan 22, 2008 | GE WBVH6240F Front Load Washer

Not finding what you are looking for?
Frigidaire Affinity ATF7000E Front Load Washer Logo

307 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Washing Machines Experts

Electrolux
Electrolux

Level 3 Expert

4342 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Are you a Frigidaire Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...