Question about Heating & Cooling

1 Answer

PALOMA GAS HEATERS GOES OUT AFTER 10 SECS - Heating & Cooling

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Prodigy:

    An expert who has answered 500 questions.

  • Expert
  • 540 Answers

Checkout the manufactures webpage and model#.

Posted on Sep 03, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Very loud rattling sound on start up of laser 56 Toyostove that wakes me from a dead sleep. Why is that? Please help!


were I you I would call a professional plumber and or your gas supplier to check this problem .

Jan 04, 2017 | Heating & Cooling

1 Answer

I have a older Carrier heat pump, model 38YKC060. Does anyone know how cold it will continue to work at?


Heat pumps are of little or no value at temps around 40 degrees or below. And if you use the strips it will cost a small fortune if you have relatively high electric rates as most folks do.

Jan 04, 2017 | Heating & Cooling

1 Answer

My Coleman furnace 4322/729 model lights the pilot but won't cut in . What could be problem ? Cleared lines Complete


Gas valve not opening? Does it have the exhaust blower that pulls vacuum switch allowing burner to light?
(1) Thermostat not working? Has to complete the circuit in or gas valve to open.
(2)Can be a stuck or bad gas valve. Try tapping the side of the gas valve body while thermostat is calling for heat. Tapping,not pounding. Like lightly,yannow? don-ohio (:^)

Jan 03, 2017 | Coleman Heating & Cooling

2 Answers

Replaced ac unit with new compressor. Fires up as usual but compressor wont start.No fault code coming on controller. Whats the problem?


possible causes include
excessive gas
low gas
relay not working,
faulty thermostat
faulty start/run capacitor
bad circuit board

Jan 03, 2017 | Heating & Cooling

1 Answer

How do I fix my electric heater


  • sounds like the sensor or bulb that tells it to start the blower is defective/ im not familiar with your unit but this seems the most logical answer most furnace will not turn the blower on right away usually 90 seconds after the ignition but will also run longer to exhume any dangerous carbon monoxide. Electricic heaters are different. What type of unit do you have

Dec 25, 2014 | Heating & Cooling

1 Answer

Cannot get gas to flow to pilot flame with main valve parallel to gas pipe. Is there something I must push to make gas flow to the pilot flame pipe?


you said, in effect: Cannot get gas to light the pilot flame even though manual supply valve is open. Is there something I must push to light [ignite] the pilot? Permalink
The gas supply valve is open, and the pilot gas cutoff valve is open but [it seems like] gas will not flow to the pilot flame because it will not light when I supply a match or lighter flame. I remember there is a button or something I need to press...but where it it? I cannot find it.

Nov 03, 2014 | Heating & Cooling

1 Answer

Propane cylinder leaks


flick the little point as it may not be seating correctly. IF it still leaks attach the torch again and take it to a gas fitter and have it fixed . Remember that with gas what is in that little bottle can destroy you and your car if it is allowed to escape and ignite.

Jan 26, 2014 | Heating & Cooling

1 Answer

Igniter or gas valve problem


It could be a connector or wiring defect.

Jan 19, 2014 | Heating & Cooling

1 Answer

Heat will not blow hot air model #310aavo48090oabjd serial #0205a42429


give name make of unit and set up of system oil/gas ect...

Oct 28, 2012 | Heating & Cooling

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

paulcarew

Level 3 Expert

2097 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Donni Steen

Level 3 Expert

659 Answers

Are you a Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...