how do i amend pressure bar on worcester 28si as either below zero or close to 3 in the red.Also how...
(More)
how do i amend pressure bar on worcester 28si as either below zero or close to 3 in the red.Also how can i check my controls are set right as my gas bills very very high and gas co said maybe water setting too high as we are hardly home so dont have heating on much at all
I rent my place and the stove has just functioned according to the temperature I set. However on day...
(More)
I rent my place and the stove has just functioned according to the temperature I set. However on day it stopped and displayed 12:00 flashing. I had only ever seen a temperate there, one desired and the other reality. I had keep thinking it was out of fuel, but I played with buttons a bit and it started working again. Only now it shows time???? I see at the bottom it says 'Start set back' & 'End set back' Please tell me what I need to do!
i have a hydrotherm boiler with a millivolt gas valve and when i go to hook my thermostat wires up...
(More)
i have a hydrotherm boiler with a millivolt gas valve and when i go to hook my thermostat wires up the pilot drops way down and my millivolt reading drops to 16mv why is that
Traditional water heaters use a storage tank to hol... Read More
Traditional water heaters use a storage tank to hold heated water until it is needed. They typically run off of natural gas, but electric and propane heaters are also common. In addition, tank less water heaters are available. They operate by routing water to where it needs to be instead of storing