20 Most Recent
Jandy LRZ400EN Legacy Pool Heater 400K BTU Nat Gas - Page 3 Questions & Answers
I have a jandy AE TI heater says it is in defrost mode and will not kick on
If this is a problem only when the air temp out side is cooler than normal and your water temp is low, then the unit is performing correctly. The heatpump is having trouble performing with low ambient air temp because when the temp gets to low the coil will ice up. You may also have a bad defrost sensor (coil temp sensor).
Low coil temperature on jandy air energy titanium pool heater
If this is a problem only when the air temp out side is cooler than normal and your water temp is low, then the unit is performing correctly. The heatpump is having trouble performing with low ambient air temp because when the temp gets to low the coil will ice up.
Error code High Ref Pressure on a jandy AE 3000T-R
Make sure your water filters are clean and if you have an external by-pass, make sure it is not open. High Ref Pressure is normally caused when the refrigerant is not cooled off by the pool water circulating thru the heat exchanger. If your filter pump is not circulating enough water (normally around 40gpm) in the system then you will trip the high pressure sensor. If the HP sensor trips without the compressor engaging the try replacing the sensor.
Not finding what you are looking for?